[U-Boot] [PATCH] nitrogen6x: Fix the PAD settings for the ECSPI chipselect

[Troy Kisky <troy.kisky@boundarydevices.com>]

On 4/12/2014 3:54 PM, Eric Nelson wrote:
> Hi Fabio,
> 
> On 04/11/2014 01:43 PM, Fabio Estevam wrote:
>> From: Fabio Estevam <fabio.estevam@freescale.com>
>>
>> ECSPI chipselect (MX6_PAD_EIM_D19__GPIO3_IO19) is used with GPIO functionality,
>> so it does not make sense to set its pad as SPI pin.
>>
>> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
>> ---
>> Eric,
>>
>> This is untested.
>>
>>   board/boundary/nitrogen6x/nitrogen6x.c | 2 +-
>>   1 file changed, 1 insertion(+), 1 deletion(-)
>>
>> diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c
>> index d9c05b0..f2492e4 100644
>> --- a/board/boundary/nitrogen6x/nitrogen6x.c
>> +++ b/board/boundary/nitrogen6x/nitrogen6x.c
>> @@ -331,7 +331,7 @@ int board_mmc_init(bd_t *bis)
>>   #ifdef CONFIG_MXC_SPI
>>   iomux_v3_cfg_t const ecspi1_pads[] = {
>>       /* SS1 */
>> -    MX6_PAD_EIM_D19__GPIO3_IO19   | MUX_PAD_CTRL(SPI_PAD_CTRL),
>> +    MX6_PAD_EIM_D19__GPIO3_IO19  | MUX_PAD_CTRL(NO_PAD_CTRL),
>>       MX6_PAD_EIM_D17__ECSPI1_MISO | MUX_PAD_CTRL(SPI_PAD_CTRL),
>>       MX6_PAD_EIM_D18__ECSPI1_MOSI | MUX_PAD_CTRL(SPI_PAD_CTRL),
>>       MX6_PAD_EIM_D16__ECSPI1_SCLK | MUX_PAD_CTRL(SPI_PAD_CTRL),
>>
> 
> Tested-by: Eric Nelson <eric.nelson@boundarydevices.com>
> Acked-by: Eric Nelson <eric.nelson@boundarydevices.com>

NAK. Please don't use NO_PAD_CTRL. What is wrong with
SPI_PAD_CTRL. Your commit message doesn't say.
It is an SPI pin (even if used as a GPIO,) so
why doesn't it make sense.

I think your fixing a problem that doesn't exist.

Troy