Re: [PATCH RFC 1/2] Documentation: add Device tree bindings for QCA7000

[Stefan Wahren <stefan.wahren@i2se.com>]

Hi Arnd,

Am 28.04.2014 21:57, schrieb Arnd Bergmann:
> On Monday 28 April 2014 19:54:56 Stefan Wahren wrote:
>> This patch adds the Device tree bindings for the Ethernet over SPI
>> protocol driver of the Qualcomm QCA7000 HomePlug GreenPHY.
>>
>> Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
>> ---
>>  .../devicetree/bindings/net/qca-qca7000-spi.txt    |   51 ++++++++++++++++++++
>>  1 file changed, 51 insertions(+)
>>  create mode 100644 Documentation/devicetree/bindings/net/qca-qca7000-spi.txt
>>
>> diff --git a/Documentation/devicetree/bindings/net/qca-qca7000-spi.txt b/Documentation/devicetree/bindings/net/qca-qca7000-spi.txt
>> new file mode 100644
>> index 0000000..132c10f
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/net/qca-qca7000-spi.txt
>> @@ -0,0 +1,51 @@
>> +* Qualcomm QCA7000 (Ethernet over SPI protocol)
>> +
>> +Note: The QCA7000 is useable as a SPI device. In this case it must be defined
>> +as a child of a spi master in the device tree.
>> +
>> +Required properties:
>> +- compatible : Should be "qca,qca7000"
>> +- reg : Should specify the SPI chip select
>> +- intr-gpios : Should specify the GPIO for SPI interrupt
>> +- spi-cpha : Must be set
>> +- spi-cpol: Must be set
> Why specify the interrupt as a GPIO line, rather than an 'interrupts' property?
>
> 	Arnd
>

i thought the extra interrupt line must be defined as a GPIO. I will fix
that.

Is the rest of the bindings ok?

Kind regards,
Stefan