[U-Boot] [PATCH 1/3] usb: tegra: fix PHY selection code

[Stephen Warren <swarren@wwwdotorg.org>]

On 05/01/2014 04:49 AM, Marek Vasut wrote:
> On Wednesday, April 30, 2014 at 11:09:55 PM, Stephen Warren wrote:
>> From: Stephen Warren <swarren@nvidia.com>
>>
>> The TRM for Tegra30 and later all state that USBMODE_CM_HC must be set
>> before writing to hostpc1_devlc to select which PHY to use for a USB
>> controller. However, neither init_{utmi,ulpi}_usb_controller() do this
>> today, so the register writes they perform for PHY selection do not
>> work.
>>
>> For the UTMI case, this was hacked around in commit 7e44d9320ed4 "ARM:
>> Tegra: USB: EHCI: Add support for Tegra30/Tegra114" by adding code to
>> ehci_hcd_init() which sets USBMODE_CM_HC and duplicates the PHY
>> selection register write. This code doesn't cover the ULPI case, so I
>> wouldn't be surprised if ULPI doesn't work with the current code, unless
>> the ordering requirement only ends up being an issue in HW for UTMI not
>> ULPI.
>>
>> This patch fixes init_{utmi,ulpi}_usb_controller() to correctly set
>> USBMODE_CM_HC before selecting the PHY. Now that this works, we can
>> remove the duplicate UTMI-specific code in ehci_hcd_init(), thus
>> simplifying that function.
> 
> This doesn't apply on u-boot-usb/master , so I cannot pick this, sorry .

Ah right. That's because I'm working on top of a merge of
u-boot-arm/master and u-boot/master, and that includes the following
changes to the Tegra USB driver that went in through u-boot-tegra/master
-> u-boot-arm/master rather than the USB tree:

8f9fd6caafb8 usb: tegra: combine header file
b1d615f3f102 usb: tegra: fix PHY configuration
b03f4b3742a7 usb: tegra: fix USB2 powerdown for Tegra30 and later

What's the best fix here:

* Wait until the previous patches get into u-boot/master, and
u-boot-usb/master picks them up, and then apply this series.

* Apply this series to u-boot-tegra/master with your ack?

There's little point my rebasing this series on top of
u-boot-usb/master, and applying it right now, since that will just cause
the same conflicts when u-boot-usb/master gets merged into u-boot/master.

Thanks.