Re: [PATCHv2 2/2] Documentation: dt: add an optional dma-desc-enable property for dwc2 usb

[Sergei Shtylyov <sergei.shtylyov-M4DtvfQ/ZS1MRgGoP+s0PdBPR1lH4CV8@public.gmane.org>]

Hello.

On 07-05-2014 3:00, dinguyen-EIB2kfCEclfQT0dZR+AlfA@public.gmane.org wrote:

> From: Dinh Nguyen <dinguyen-EIB2kfCEclfQT0dZR+AlfA@public.gmane.org>

> The "dma-desc-enable" property can be used to enable descriptor DMA mode
> for the DWC2 USB IP.

> Signed-off-by: Dinh Nguyen <dinguyen-EIB2kfCEclfQT0dZR+AlfA@public.gmane.org>
> ---
> v2: Reword property description to enable instead of disable
> ---
>   Documentation/devicetree/bindings/usb/dwc2.txt |    7 +++++++
>   1 file changed, 7 insertions(+)

> diff --git a/Documentation/devicetree/bindings/usb/dwc2.txt b/Documentation/devicetree/bindings/usb/dwc2.txt
> index b8b6871..9b471b5 100644
> --- a/Documentation/devicetree/bindings/usb/dwc2.txt
> +++ b/Documentation/devicetree/bindings/usb/dwc2.txt
> @@ -14,6 +14,13 @@ Refer to clk/clock-bindings.txt for generic clock consumer properties
>   Optional properties:
>   - phys: phy provider specifier
>   - phy-names: shall be "device"
> +- dma-desc-enable: Should be <1> to enable descriptor dma mode. This
> +	property is used to enable descriptor DMA support. The reason why
> +	this property is needed is because the HW supports descriptor DMA
> +	mode, but descriptor dma mode will not support SPLIT transactions.
> +	So this property can be used to optionally enable descriptor DMA
> +	support.

    Why not make this property boolean?

WBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html