From mboxrd@z Thu Jan 1 00:00:00 1970 From: York Sun Date: Wed, 7 May 2014 13:29:36 -0700 Subject: [U-Boot] [PATCH 12/12] imx: ventana: switch to SPL In-Reply-To: References: <1398716258-8420-1-git-send-email-tharvey@gateworks.com> <1398716258-8420-13-git-send-email-tharvey@gateworks.com> <1399403502.2123.11.camel@yellow> <536A5BCD.9070406@freescale.com> Message-ID: <536A97B0.4090007@freescale.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 05/07/2014 01:27 PM, Tim Harvey wrote: > On Wed, May 7, 2014 at 9:14 AM, York Sun wrote: >> On 05/06/2014 04:35 PM, Tim Harvey wrote: >>> On Tue, May 6, 2014 at 12:11 PM, Jeroen Hofstee wrote: >>>> Hello Tim, >>>> >> >>>> >>>> Since Crt0.S already created gd on the stack before calling >>>> board_init_f, can't the assignment of gd not simply be removed? >>>> Is there anything special about gdata? >>>> >>>> Regards, >>>> Jeroen >>>> >>>> >>> >>> Jeroen, >>> >>> That does make sense, but what I find is that York's ocmmit >>> dec1861be90c948ea9fb771927d3d26a994d2e20 requires that gd be blanked >>> and its not. This causes bus_i2c_init to skip its initialization >>> because p->base is not zero. >>> >>> York, does this make sense? Your patch creates a dependence on >>> gd->srdata being blank which isn't the case with the SRAM when booting >>> from the IMX6 boot rom. >>> >> >> GD should be cleared (zeroed). Then we don't have this problem. Whoever sets up >> gd (board_int_f, cpu_init_f, or others) should make sure gd is cleared. Why >> isn't it the case for IMX6 boot rom? >> >> York >> > > York, > > crt0.S is mapping gd to where the SPL stack pointer is defined, which > is where Freescale says its stack pointer is for its firmware BOOT > ROM, so its initial data will be dependent on what the BOOT ROM did. > > I think the right solution is to have crt0.S zero it out. > Either crt0.S, or somewhere before gd is used for the first time. Can it be done in board_init_f()? York