From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from mail2.candelatech.com ([208.74.158.173]) by bombadil.infradead.org with esmtp (Exim 4.80.1 #2 (Red Hat Linux)) id 1WntBV-0007Wc-G1 for ath10k@lists.infradead.org; Fri, 23 May 2014 17:23:09 +0000 Message-ID: <537F83E7.2090504@candelatech.com> Date: Fri, 23 May 2014 10:22:47 -0700 From: Ben Greear MIME-Version: 1.0 Subject: Re: changing channel width References: In-Reply-To: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: "ath10k" Errors-To: ath10k-bounces+kvalo=adurom.com@lists.infradead.org To: Phil Moora Cc: ath10k On 05/23/2014 10:03 AM, Phil Moora wrote: > Hi all, > > I am trying to change the channel width (20, 40 or 80 MHz) with ath10k > using iw. I am not able to do so dynamically (while the radio is > operating in managed or AP mode). In some cases, it is not possible to > change channel width even when radio is off (ifconfig down). I always > get "Device busy" error. > > Is it true that with current Ath10k, we have to reset the radio to > change the channel width? Is there a workaround? > > I am using Compex WLE900N5-18 miniPCIe (hw2) with latest ath10k. Can you just configure hostapd to use the proper channel width? Thanks, Ben > > _______________________________________________ > ath10k mailing list > ath10k@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/ath10k > -- Ben Greear Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k