[RFC PATCH 3/9] irqchip: GIC: Convert to EOImode == 1

[marc.zyngier@arm.com (Marc Zyngier)]

On 25/06/14 15:06, Peter Maydell wrote:
> On 25 June 2014 10:28, Marc Zyngier <marc.zyngier@arm.com> wrote:
>> For this case, the GIC architecture provides EOImode == 1, where:
>> - A write to the EOI register drops the priority of the interrupt and leaves
>> it active. Other interrupts at the same priority level can now be taken,
>> but the active interrupt cannot be taken again
>> - A write to the DIR marks the interrupt as inactive, meaning it can
>> now be taken again.
>>
>> We only enable this feature when booted in HYP mode. Also, as most device
>> trees are broken (they report the CPU interface size to be 4kB, while
>> the GICv2 CPU interface size is 8kB), output a warning if we're booted
>> in HYP mode, and disable the feature.
> 
> Does that mean you guarantee not to write to the DEACTIVATE register
> if not booted in Hyp mode? I ask because QEMU's GIC emulation doesn't
> emulate that register, so it would be useful to know if this patch
> means newer kernels are going to fall over under TCG QEMU...

So far, I only plan to support it when booted in HYP. But it may be that
the split prio-drop/deactivate is also beneficial to threaded
interrupts, saving the writes to the distributor to mask/unmask. That
would require to be a bit more subtle in identifying a GICv2
implementation (DT binding, probably).

	M.
-- 
Jazz is not dead. It just smells funny...