From: "Li, Aubrey" <aubrey.li@linux.intel.com>
To: "H. Peter Anvin" <hpa@linux.intel.com>,
"alan@linux.intel.com" <alan@linux.intel.com>,
Adam Williamson <awilliam@redhat.com>,
LKML <linux-kernel@vger.kernel.org>
Subject: [Resend PATCHv3 1/3] X86 platform: New Intel Atom SOC power management controller driver
Date: Mon, 30 Jun 2014 14:08:42 +0800 [thread overview]
Message-ID: <53B0FEEA.3010805@linux.intel.com> (raw)
The Power Management Controller (PMC) controls many of the power
management features present in the Atom SoC. This driver provides
a native power off function via PMC PCI IO port.
On some ACPI hardware-reduced platforms(e.g. ASUS-T100), ACPI sleep
registers are not valid so that (*pm_power_off)() is not hooked by
acpi_power_off(). The power off function in this driver is installed
only when pm_power_off is NULL.
Signed-off-by: Aubrey Li <aubrey.li@linux.intel.com>
Signed-off-by: Lejun Zhu <lejun.zhu@linux.intel.com>
---
arch/x86/Kconfig | 4 ++
arch/x86/include/asm/pmc_atom.h | 31 ++++++++++++
arch/x86/kernel/Makefile | 1 +
arch/x86/kernel/pmc_atom.c | 104 +++++++++++++++++++++++++++++++++++++++
4 files changed, 140 insertions(+)
create mode 100644 arch/x86/include/asm/pmc_atom.h
create mode 100644 arch/x86/kernel/pmc_atom.c
diff --git a/arch/x86/Kconfig b/arch/x86/Kconfig
index a8f749e..6295a21 100644
--- a/arch/x86/Kconfig
+++ b/arch/x86/Kconfig
@@ -2403,6 +2403,10 @@ config IOSF_MBI
default m
depends on PCI
+config PMC_ATOM
+ def_bool y
+ depends on PCI
+
source "net/Kconfig"
source "drivers/Kconfig"
diff --git a/arch/x86/include/asm/pmc_atom.h b/arch/x86/include/asm/pmc_atom.h
new file mode 100644
index 0000000..03a2769
--- /dev/null
+++ b/arch/x86/include/asm/pmc_atom.h
@@ -0,0 +1,31 @@
+/*
+ * Intel Atom SOC Power Management Controller Header File
+ * Copyright (c) 2014, Intel Corporation.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms and conditions of the GNU General Public License,
+ * version 2, as published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope it will be useful, but WITHOUT
+ * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
+ * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
+ * more details.
+ *
+ */
+
+#ifndef PMC_ATOM_H
+#define PMC_ATOM_H
+
+/* ValleyView Power Control Unit PCI Device ID */
+#define PCI_DEVICE_ID_VLV_PMC 0x0F1C
+
+/* PMC I/O Registers */
+#define ACPI_BASE_ADDR_OFFSET 0x40
+#define ACPI_BASE_ADDR_MASK 0xFFFFFE00
+#define ACPI_MMIO_REG_LEN 0x100
+
+#define PM1_CNT 0x4
+#define SLEEP_TYPE_MASK 0xFFFFECFF
+#define SLEEP_TYPE_S5 0x1C00
+#define SLEEP_ENABLE 0x2000
+#endif /* PMC_ATOM_H */
diff --git a/arch/x86/kernel/Makefile b/arch/x86/kernel/Makefile
index 047f9ff..bde3993 100644
--- a/arch/x86/kernel/Makefile
+++ b/arch/x86/kernel/Makefile
@@ -106,6 +106,7 @@ obj-$(CONFIG_EFI) += sysfb_efi.o
obj-$(CONFIG_PERF_EVENTS) += perf_regs.o
obj-$(CONFIG_TRACING) += tracepoint.o
obj-$(CONFIG_IOSF_MBI) += iosf_mbi.o
+obj-$(CONFIG_PMC_ATOM) += pmc_atom.o
###
# 64 bit specific files
diff --git a/arch/x86/kernel/pmc_atom.c b/arch/x86/kernel/pmc_atom.c
new file mode 100644
index 0000000..9eb79f6
--- /dev/null
+++ b/arch/x86/kernel/pmc_atom.c
@@ -0,0 +1,104 @@
+/*
+ * Intel Atom SOC Power Management Controller Driver
+ * Copyright (c) 2014, Intel Corporation.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms and conditions of the GNU General Public License,
+ * version 2, as published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope it will be useful, but WITHOUT
+ * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
+ * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
+ * more details.
+ *
+ */
+
+#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
+
+#include <linux/module.h>
+#include <linux/init.h>
+#include <linux/pci.h>
+#include <linux/device.h>
+#include <linux/io.h>
+
+#include <asm/pmc_atom.h>
+
+static u32 acpi_base_addr;
+
+static void pmc_power_off(void)
+{
+ u16 pm1_cnt_port;
+ u32 pm1_cnt_value;
+
+ pr_info("Preparing to enter system sleep state S5\n");
+
+ pm1_cnt_port = acpi_base_addr + PM1_CNT;
+
+ pm1_cnt_value = inl(pm1_cnt_port);
+ pm1_cnt_value &= SLEEP_TYPE_MASK;
+ pm1_cnt_value |= SLEEP_TYPE_S5;
+ pm1_cnt_value |= SLEEP_ENABLE;
+
+ outl(pm1_cnt_value, pm1_cnt_port);
+}
+
+static int pmc_setup_dev(struct pci_dev *pdev)
+{
+ /* Obtain ACPI base address */
+ pci_read_config_dword(pdev, ACPI_BASE_ADDR_OFFSET, &acpi_base_addr);
+ acpi_base_addr &= ACPI_BASE_ADDR_MASK;
+
+ /* Install power off function */
+ if (acpi_base_addr != 0 && pm_power_off == NULL)
+ pm_power_off = pmc_power_off;
+
+ return 0;
+}
+
+/*
+ * Data for PCI driver interface
+ *
+ * This data only exists for exporting the supported
+ * PCI ids via MODULE_DEVICE_TABLE. We do not actually
+ * register a pci_driver, because lpc_ich will register
+ * a driver on the same PCI id.
+ */
+static const struct pci_device_id pmc_pci_ids[] = {
+ { PCI_DEVICE(PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_VLV_PMC) },
+ { 0, },
+};
+
+MODULE_DEVICE_TABLE(pci, pmc_pci_ids);
+
+static int __init pmc_atom_init(void)
+{
+ int err = -ENODEV;
+ struct pci_dev *pdev = NULL;
+ const struct pci_device_id *ent;
+
+ /* We look for our device - PCU PMC
+ * we assume that there is max. one device.
+ *
+ * We can't use plain pci_driver mechanism,
+ * as the device is really a multiple function device,
+ * main driver that binds to the pci_device is lpc_ich
+ * and have to find & bind to the device this way.
+ */
+ for_each_pci_dev(pdev) {
+ ent = pci_match_id(pmc_pci_ids, pdev);
+ if (ent) {
+ err = pmc_setup_dev(pdev);
+ goto out;
+ }
+ }
+ /* Device not found. */
+out:
+ return err;
+}
+
+module_init(pmc_atom_init);
+/* no module_exit, this driver shouldn't be unloaded */
+
+MODULE_AUTHOR("Aubrey Li <aubrey.li@linux.intel.com>");
+MODULE_DESCRIPTION("Intel Atom SOC Power Management Controller Interface");
+MODULE_LICENSE("GPL v2");
--
1.7.10.4
next reply other threads:[~2014-06-30 6:08 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-06-30 6:08 Li, Aubrey [this message]
2014-07-25 21:31 ` [tip:x86/platform] x86/platform: New Intel Atom SOC power management controller driver tip-bot for Li, Aubrey
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=53B0FEEA.3010805@linux.intel.com \
--to=aubrey.li@linux.intel.com \
--cc=alan@linux.intel.com \
--cc=awilliam@redhat.com \
--cc=hpa@linux.intel.com \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.