From: Larry Finger <Larry.Finger@lwfinger.net>
To: Johannes Berg <johannes.berg@intel.com>,
Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Cc: Intel Linux Wireless <ilw@linux.intel.com>,
linux-wireless <linux-wireless@vger.kernel.org>
Subject: Microcode SW errors for Intel 7260
Date: Fri, 04 Jul 2014 20:37:28 -0500 [thread overview]
Message-ID: <53B756D8.1080909@lwfinger.net> (raw)
The wireless device in my new Toshiba Tecra A50 reports the following when using
'lspci -nnv':
04:00.0 Network controller [0280]: Intel Corporation Wireless 7260 [8086:08b1]
(rev 73)
Subsystem: Intel Corporation Dual Band Wireless-AC 7260 [8086:4070]
Flags: bus master, fast devsel, latency 0, IRQ 48
Memory at e2400000 (64-bit, non-prefetchable) [size=8K]
Capabilities: <access denied>
Kernel driver in use: iwlwifi
Kernel modules: iwlwifi
My kernel is from the wireless-testing tree, and 'git describe' shows
master-2014-06-26-51-g956e5e6
The device seems to work OK, and is connected to channel 36 (5 GHz) with WPA2
encryption; however, it floods my logs with sequences as follows:
[367733.570361] iwlwifi 0000:04:00.0: Microcode SW error detected. Restarting
0x2000000.
[367733.570372] iwlwifi 0000:04:00.0: CSR values:
[367733.570378] iwlwifi 0000:04:00.0: (2nd byte of CSR_INT_COALESCING is
CSR_INT_PERIODIC_REG)
[367733.570396] iwlwifi 0000:04:00.0: CSR_HW_IF_CONFIG_REG: 0X40489204
[367733.570413] iwlwifi 0000:04:00.0: CSR_INT_COALESCING: 0X80000040
[367733.570430] iwlwifi 0000:04:00.0: CSR_INT: 0X00000000
[367733.570448] iwlwifi 0000:04:00.0: CSR_INT_MASK: 0X00000000
[367733.570464] iwlwifi 0000:04:00.0: CSR_FH_INT_STATUS: 0X00000000
[367733.570480] iwlwifi 0000:04:00.0: CSR_GPIO_IN: 0X00000000
[367733.570496] iwlwifi 0000:04:00.0: CSR_RESET: 0X00000000
[367733.570512] iwlwifi 0000:04:00.0: CSR_GP_CNTRL: 0X080403c5
[367733.570529] iwlwifi 0000:04:00.0: CSR_HW_REV: 0X00000144
[367733.570581] iwlwifi 0000:04:00.0: CSR_EEPROM_REG: 0X00000000
[367733.570605] iwlwifi 0000:04:00.0: CSR_EEPROM_GP: 0X80000000
[367733.570633] iwlwifi 0000:04:00.0: CSR_OTP_GP_REG: 0X803a0000
[367733.570659] iwlwifi 0000:04:00.0: CSR_GIO_REG: 0X00080042
[367733.570678] iwlwifi 0000:04:00.0: CSR_GP_UCODE_REG: 0X00000000
[367733.570698] iwlwifi 0000:04:00.0: CSR_GP_DRIVER_REG: 0X00000000
[367733.570718] iwlwifi 0000:04:00.0: CSR_UCODE_DRV_GP1: 0X00000000
[367733.570738] iwlwifi 0000:04:00.0: CSR_UCODE_DRV_GP2: 0X00000000
[367733.570758] iwlwifi 0000:04:00.0: CSR_LED_REG: 0X00000060
[367733.570779] iwlwifi 0000:04:00.0: CSR_DRAM_INT_TBL_REG: 0X88220a0d
[367733.570804] iwlwifi 0000:04:00.0: CSR_GIO_CHICKEN_BITS: 0X27800200
[367733.570825] iwlwifi 0000:04:00.0: CSR_ANA_PLL_CFG: 0Xd55555d5
[367733.570845] iwlwifi 0000:04:00.0: CSR_MONITOR_STATUS_REG: 0X3c08019d
[367733.570864] iwlwifi 0000:04:00.0: CSR_HW_REV_WA_REG: 0X0001001a
[367733.570884] iwlwifi 0000:04:00.0: CSR_DBG_HPET_MEM_REG: 0Xffff0000
[367733.570892] iwlwifi 0000:04:00.0: FH register values:
[367733.570924] iwlwifi 0000:04:00.0: FH_RSCSR_CHNL0_STTS_WPTR_REG:
0X0c05ff00
[367733.570953] iwlwifi 0000:04:00.0: FH_RSCSR_CHNL0_RBDCB_BASE_REG:
0X00c06000
[367733.570984] iwlwifi 0000:04:00.0: FH_RSCSR_CHNL0_WPTR:
0X00000028
[367733.571010] iwlwifi 0000:04:00.0: FH_MEM_RCSR_CHNL0_CONFIG_REG:
0X80801114
[367733.571036] iwlwifi 0000:04:00.0: FH_MEM_RSSR_SHARED_CTRL_REG:
0X000000fc
[367733.571063] iwlwifi 0000:04:00.0: FH_MEM_RSSR_RX_STATUS_REG:
0X07030000
[367733.571089] iwlwifi 0000:04:00.0: FH_MEM_RSSR_RX_ENABLE_ERR_IRQ2DRV:
0X00000000
[367733.571116] iwlwifi 0000:04:00.0: FH_TSSR_TX_STATUS_REG:
0X07ff0001
[367733.571142] iwlwifi 0000:04:00.0: FH_TSSR_TX_ERROR_REG:
0X00000000
[367733.571281] iwlwifi 0000:04:00.0: Start IWL Error Log Dump:
[367733.571286] iwlwifi 0000:04:00.0: Status: 0x00000000, count: 6
[367733.571290] iwlwifi 0000:04:00.0: Loaded firmware version: 23.214.9.0
[367733.571294] iwlwifi 0000:04:00.0: 0x0000277B | ADVANCED_SYSASSERT
[367733.571298] iwlwifi 0000:04:00.0: 0x000002B0 | uPc
[367733.571301] iwlwifi 0000:04:00.0: 0x00000000 | branchlink1
[367733.571305] iwlwifi 0000:04:00.0: 0x00000BA4 | branchlink2
[367733.571308] iwlwifi 0000:04:00.0: 0x000166A4 | interruptlink1
[367733.571312] iwlwifi 0000:04:00.0: 0x00DB0DD3 | interruptlink2
[367733.571316] iwlwifi 0000:04:00.0: 0x00000024 | data1
[367733.571319] iwlwifi 0000:04:00.0: 0x00000018 | data2
[367733.571323] iwlwifi 0000:04:00.0: 0xDEADBEEF | data3
[367733.571326] iwlwifi 0000:04:00.0: 0x003BE407 | beacon time
[367733.571330] iwlwifi 0000:04:00.0: 0x00041C14 | tsf low
[367733.571333] iwlwifi 0000:04:00.0: 0x00000000 | tsf hi
[367733.571337] iwlwifi 0000:04:00.0: 0x00000000 | time gp1
[367733.571340] iwlwifi 0000:04:00.0: 0x00041C14 | time gp2
[367733.571345] iwlwifi 0000:04:00.0: 0x00000000 | time gp3
[367733.571349] iwlwifi 0000:04:00.0: 0x000417D6 | uCode version
[367733.571353] iwlwifi 0000:04:00.0: 0x00000144 | hw version
[367733.571357] iwlwifi 0000:04:00.0: 0x40489204 | board version
[367733.571362] iwlwifi 0000:04:00.0: 0x0000001C | hcmd
[367733.571366] iwlwifi 0000:04:00.0: 0x00022000 | isr0
[367733.571370] iwlwifi 0000:04:00.0: 0x00000000 | isr1
[367733.571374] iwlwifi 0000:04:00.0: 0x00000002 | isr2
[367733.571378] iwlwifi 0000:04:00.0: 0x0040D0C0 | isr3
[367733.571382] iwlwifi 0000:04:00.0: 0x00000000 | isr4
[367733.571386] iwlwifi 0000:04:00.0: 0x00000110 | isr_pref
[367733.571390] iwlwifi 0000:04:00.0: 0x00000000 | wait_event
[367733.571394] iwlwifi 0000:04:00.0: 0x00000080 | l2p_control
[367733.571398] iwlwifi 0000:04:00.0: 0x00010000 | l2p_duration
[367733.571402] iwlwifi 0000:04:00.0: 0x0000003F | l2p_mhvalid
[367733.571406] iwlwifi 0000:04:00.0: 0x00000080 | l2p_addr_match
[367733.571410] iwlwifi 0000:04:00.0: 0x00000005 | lmpm_pmg_sel
[367733.571415] iwlwifi 0000:04:00.0: 0x18051651 | timestamp
[367733.571419] iwlwifi 0000:04:00.0: 0x00002830 | flow_handler
[367733.571428] ieee80211 phy0: Hardware restart was requested
[367733.572094] iwlwifi 0000:04:00.0: L1 Enabled; Disabling L0S
[367733.572457] iwlwifi 0000:04:00.0: L1 Enabled; Disabling L0S
Please inform me of any further info that is needed.
Thanks,
Larry
next reply other threads:[~2014-07-05 1:37 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-07-05 1:37 Larry Finger [this message]
2014-07-05 18:10 ` Microcode SW errors for Intel 7260 Emmanuel Grumbach
2014-07-06 4:29 ` Larry Finger
2014-07-06 4:56 ` Emmanuel Grumbach
2014-07-06 16:11 ` Larry Finger
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=53B756D8.1080909@lwfinger.net \
--to=larry.finger@lwfinger.net \
--cc=emmanuel.grumbach@intel.com \
--cc=ilw@linux.intel.com \
--cc=johannes.berg@intel.com \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.