[U-Boot] [PATCH V4] ARM: mx6: Add support for Kosagi Novena

[Nikolay Dimitrov <picmaster@mail.bg>]

Hi Marek,

Some comments about SPI:

On 09/23/2014 01:18 PM, Marek Vasut wrote:
> +/*
> + * SPI
> + */
> +#ifdef CONFIG_MXC_SPI
> +static iomux_v3_cfg_t ecspi1_pads[] = {
> +	/* SS1 */
> +	MX6_PAD_EIM_D19__GPIO3_IO19   | MUX_PAD_CTRL(SPI_PAD_CTRL),
> +	MX6_PAD_EIM_D17__ECSPI1_MISO | MUX_PAD_CTRL(SPI_PAD_CTRL),
> +	MX6_PAD_EIM_D18__ECSPI1_MOSI | MUX_PAD_CTRL(SPI_PAD_CTRL),
> +	MX6_PAD_EIM_D16__ECSPI1_SCLK | MUX_PAD_CTRL(SPI_PAD_CTRL),
> +};
> +
> +static void novena_spl_setup_iomux_spi(void)
> +{
> +	imx_iomux_v3_setup_multiple_pads(ecspi1_pads, ARRAY_SIZE(ecspi1_pads));
> +	gpio_direction_output(CONFIG_SF_DEFAULT_CS, 1);
> +}
> +#else
> +static void novena_spl_setup_iomux_spi(void) {}
> +#endif

I checked the schematic and didn't saw any usage of ECSPI1. In addition, 
these pads (EIM D16/17/18/19) are used by other interfaces. Can you 
please also double-check this?

Kind regards,
Nikolay