Hi,

Thanks for your input on our issue.

The problem is, in our custom board there is no USB OTG port.  For 
programming, we are using JTAG debugger.
With Linux-3.0.35 based BSP we are able to program/boot the target.  
But  imx-3.10.17 GA based BSP we are not able to boot/program the target.

Thank You,
Regards,
Ansari


On Thursday 16 October 2014 09:37 PM, Otavio Salvador wrote:
> On Thu, Oct 16, 2014 at 12:25 PM, ansaris <ansaris@iwavesystems.com> wrote:
>> We are using linux-3.10.17 BSP(u-boot-3.10 YOCTO) with solo(512MB) processor
>> custom imx6 board.
>>
>> I have downloaded the u-boot.imx(or u-boot.bin) into DDR using JTAG debugger
>> to the memory address 0x17800000.
>> I have followed the below mentioned steps:
>> 1) memory load tftp://192.168.0.1/u-boot.imx bin 0x17800000
>> 2)set cpsr 0xD3
>> 3) set sp 0x200
>> 4)set pc 0x17800000
>> 5)go
>>
>> But target board is not booting.
>>
>> We tried the same with linux-3.0 BSP by following steps:
>> 1) memory load tftp://192.168.0.1/u-boot.imx bin 0x27800000
>> 2)set cpsr 0xD3
>> 3) set sp 0x200
>> 4)set pc 0x27800bc0
>> 5)go
>>
>> After this, the target board is booting properly.
>>
>> Whether any changes required to load and boot 3.10 version u-boot?
>> Please suggest us.
> Why you don't use USB loader for this? We used it daily and it works very well.
>