Re: DPDK on Xen Dom-U hangs during hugepage setup

[Murillo <imurillo006-+ngl/9zrRLQ@public.gmane.org>]

Hello Kiran,

I was able to execute the helloworld example by running the next steps:

Change in Dpdk/config/common_linuxapp
CONFIG_RTE_LIBRTE_XEN_DOM0=n
to:
CONFIG_RTE_LIBRTE_XEN_DOM0=y
Change indpdk/config/defconfig_x86_64-native-linuxapp-gcc
CONFIG_RTE_MACHINE="native"
To
CONFIG_RTE_MACHINE="default"
make config T=x86_64-native-linuxapp-gcc
make install T=x86_64-native-linuxapp-gcc
sudo modprobe uio
sudo insmod x86_64-native-linuxapp-gcc/kmod/igb_uio.ko
sudo insmod x86_64-native-linuxapp-gcc/kmod/rte_dom0_mm.ko rsv_memsize=2048
echo 2048 /sys/kernel/mm/dom0-mm/memsize-mB/memsize
cd example/helloworld
make
./build/helloworld -c 0x3 -n 2 --xen-dom0 –no-huge



El 31/10/14 a las 19:08, Kiran KN escribió:
> Hello Murillo,
>
> Yes, am using rte_dom0_mm as explained in DPDK programmers guide section 14.3.3 step (4).
>
> The examples work when using --no-huge option.
>
> Are you able to go past the hugepage setup? If so can you tell what are the steps you followed in addition to the ones explained in section 14.3.
>
> Thanks,
>   Kiran
>
> -----Original Message-----
> From: dev [mailto:dev-bounces-VfR2kkLFssw@public.gmane.org] On Behalf Of Murillo
> Sent: Friday, October 31, 2014 1:11 AM
> To: dev-VfR2kkLFssw@public.gmane.org
> Subject: Re: [dpdk-dev] DPDK on Xen Dom-U hangs during hugepage setup
>
> Hello,
>
> Xen does not support hugepages, so you have to use a kernel module called rte_dom0_mm.
> The instructions are in the getting started guide in the seccion 2.3.3.
> If you manage to execute any example please tell me, because I am stuck during the execution of the examples after configuring the environment.
>
>
>
> El 30/10/14 a las 19:15, Kiran KN escribió:
>> Hello,
>>
>> I am trying to bring up DPDK on Xen Dom-U.
>>
>> Have followed all the steps in DPDK programmers guide in section 14.3.
>>
>> However, when I try to run testpmd or any other example application, it is getting stuck during hugepage setup.
>>
>> It hangs after the print "EAL: Setting up memory..."
>>
>> Has anyone faced similar issue before?
>>
>> Thanks,
>>    Kiran
>>
>>