Re: am335x: cpsw: phy ignores max-speed setting

[Florian Fainelli <f.fainelli@gmail.com>]

On 11/06/2014 08:25 AM, Yegor Yefremov wrote:
> I' m trying to override max-speed setting for both CPSW connected
> PHYs. This is my DTS section for configuring CPSW:
> 
> &mac {
>         pinctrl-names = "default", "sleep";
>         pinctrl-0 = <&cpsw_default>;
>         pinctrl-1 = <&cpsw_sleep>;
>         dual_emac = <1>;
> 
>         status = "okay";
> };
> 
> &davinci_mdio {
>         pinctrl-names = "default", "sleep";
>         pinctrl-0 = <&davinci_mdio_default>;
>         pinctrl-1 = <&davinci_mdio_sleep>;
> 
>         status = "okay";
> };
> 
> &cpsw_emac0 {
>         phy_id = <&davinci_mdio>, <0>;
>         phy-mode = "rgmii-id";
>         dual_emac_res_vlan = <1>;
>         max-speed = <100>;
> };
> 
> &cpsw_emac1 {
>         phy_id = <&davinci_mdio>, <1>;
>         phy-mode = "rgmii-id";
>         dual_emac_res_vlan = <2>;
>         max-speed = <100>;
> };
> 
> But in drivers/net/phy/phy_device.c->of_set_phy_supported() routine I
> don't get through node check, i.e. node == NULL. Any idea why?

Yes, because the 'max-speed' property is placed at the Ethernet MAC node
level, not the PHY node as of_set_phy_supported() expect its.

This driver does not appear to use the standard Ethernet PHY device tree
node, so I am not sure what are your options here.

> 
> static void of_set_phy_supported(struct phy_device *phydev)
> {
>         struct device_node *node = phydev->dev.of_node;
>         u32 max_speed;
> 
>         if (!IS_ENABLED(CONFIG_OF_MDIO))
>                 return;
> 
>         if (!node)
>                 return;
> 
>         if (!of_property_read_u32(node, "max-speed", &max_speed)) {
>                 /* The default values for phydev->supported are
> provided by the PHY
>                  * driver "features" member, we want to reset to sane
> defaults fist
>                  * before supporting higher speeds.
>                  */
>                 phydev->supported &= PHY_DEFAULT_FEATURES;
> 
>                 switch (max_speed) {
>                 default:
>                         return;
> 
>                 case SPEED_1000:
>                         phydev->supported |= PHY_1000BT_FEATURES;
>                 case SPEED_100:
>                         phydev->supported |= PHY_100BT_FEATURES;
>                 case SPEED_10:
>                         phydev->supported |= PHY_10BT_FEATURES;
>                 }
>         }
> }
> 
> Yegor
> --
> To unsubscribe from this list: send the line "unsubscribe netdev" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>