[U-Boot] [PATCH 1/5] powerpc/b4860qds: add xfi support

[York Sun <yorksun@freescale.com>]

On 11/12/2014 07:26 PM, shh.xie at gmail.com wrote:
> From: Shaohui Xie <Shaohui.Xie@freescale.com>
> 
> We need following changes to make xfi work on B4:
> 1. set cross-point switch VSC3308 to use sfp config when running xfi;
> 2. add 10G interface check for xfi;
> 3. set phy address for xfi so the 10G ports can be registered by mdio;
> 
> Signed-off-by: Shaohui Xie <Shaohui.Xie@freescale.com>
> ---
>  board/freescale/b4860qds/b4860qds.c     | 40 +++++++++++++++++++++++++++------
>  board/freescale/b4860qds/eth_b4860qds.c |  6 +++++
>  drivers/net/fm/b4860.c                  |  4 +++-
>  3 files changed, 42 insertions(+), 8 deletions(-)

Applied to u-boot-mpc85xx, awaiting upstream.

York