[U-Boot] [PATCH 06/20] tegra: spi: Drop the claim_bus() method to correct delays

[Stephen Warren <swarren@wwwdotorg.org>]

On 02/17/2015 03:29 PM, Simon Glass wrote:
> At present the driver does not properly honour the requested SPI CS
> deactivation delay since the SPI bus is changed in the claim_bus() method.
>
> Everything the claim_bus() method does can be done when the device is probed
> (setting the speed and mode) and at the start of a new transfer (where the
> fifo_status is already cleared). So drop this method.
>
> Also, until the delay is complete, we should not touch the bus, so make sure
> that spi_cs_activate() is called before other things are done in the xfer()
> method.

> diff --git a/drivers/spi/tegra114_spi.c b/drivers/spi/tegra114_spi.c

> -	setbits_le32(&regs->command1, SPI_CMD1_M_S | SPI_CMD1_CS_SW_HW |
> -		     (priv->mode << SPI_CMD1_MODE_SHIFT));
...
> +	setbits_le32(&priv->regs->command1, SPI_CMD1_M_S | SPI_CMD1_CS_SW_HW |
> +		     (priv->mode << SPI_CMD1_MODE_SHIFT) | SPI_CMD1_CS_SW_VAL);

Is that addition of SPI_CMD1_CS_SW_VAL there relative to the old code 
intended?