[U-Boot] [PATCH v2 1/4] mx6cuboxi: Add HDMI output support

[Stefano Babic <sbabic@denx.de>]

On 30/04/2015 03:28, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam@freescale.com>
> 
> Add HDMI output using PLL5 as the source for the IPU clocks,
> and accurate VESA timings.
> 
> These settings are based on the patch from Soeren Moch <smoch@web.de>
> submitted for the tbs2910 mx6 based board.
> 
> It allows the display to work properly at 1024x768 at 60.
> 
> This should make the hdmi output signal compatible with most if not all
> modern displays.
> 
> Signed-off-by: Jon Nettleton <jon.nettleton@gmail.com>
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> Reviewed-by: Tom Rini <trini@konsulko.com>
> Tested-by: Tom Rini <trini@konsulko.com>
> ---


Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================