From mboxrd@z Thu Jan 1 00:00:00 1970 From: Guenter Roeck Date: Sat, 06 Jun 2015 15:01:53 +0000 Subject: Re: [lm-sensors] Parallella board temperature sensing Message-Id: <55730B61.2030207@roeck-us.net> List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org On 06/06/2015 07:51 AM, Gergely Imreh wrote: > Hi, > > I was checking out what would it take to support lm-sensors on the > Parallella board[1]. It's an interesting little board with a dual core > Xilinx ARM Cortex-A9, an FPGA, and a 16-core Epiphany co-processor. > It's Xilinx XADC sensor used for temperature/voltage sensing does not > seem to be anywhere on the lm-sensors supported device list. Currently > users seem to monitor it through reading the device data directly from > the /sys entries and doing the necessary scaling and conversion (as it > was discussed on the Parallella forums, bash script included[2]) > > In a nutshell, the data is accessible through > /sys/bus/iio/devices/iio:device0/in_temp0_{raw,offset,scale} files. > There are also 8 voltage readings there that could be extracted. > If it is supported through iio, it should be possible use the iio->hwmon bridge. Guenter _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors