Re: [Qemu-devel] [PATCH 4/4] Disable "info irq" and "info pic" for target-ppc

[Laurent Vivier <lvivier@redhat.com>]

On 29/06/2015 07:36, David Gibson wrote:
> The "info irq" and "info pic" HMP commands are available on some, but not
> all targets, and what they do isn't terribly consistent.  For SPARC and
> LM32 they do something platform specific, but for x86, powerpc, and MIPS
> they print some information from the i8259 (and only the i8259) interrupt
> controller.
> 
> It's debatable whether these commands are any use at all, and we should
> probably make better, qdev aware ways of getting information from a
> machines PICs.  However, those don't exist yet, so on x86 it's at least
> potentially useful to have these HMP commands.  I can't speak for MIPS.
> 
> For ppc, though, the i8259, if it exists at all, is usually just a
> secondary controller for legacy ISA.  The only case where i8259 is the
> main system PIC on ppc is for the ancient and little-used PReP platform.
> 
> So, even without QOM-ish replacement, the info pic and info irq HMP
> commands have no value on ppc.
> 
> This patch, therefore, disables these commands for ppc targets.  This will
> allow ppc builds which don't include PReP to not include ISA bus support
> either.
> 
> Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
> ---
>  monitor.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/monitor.c b/monitor.c
> index aeea2b5..8c56bfa 100644
> --- a/monitor.c
> +++ b/monitor.c
> @@ -2573,7 +2573,7 @@ static mon_cmd_t info_cmds[] = {
>          .help       = "show the command line history",
>          .mhandler.cmd = hmp_info_history,
>      },
> -#if defined(TARGET_I386) || defined(TARGET_PPC) || defined(TARGET_MIPS) || \
> +#if defined(TARGET_I386) || defined(TARGET_MIPS) || \
>      defined(TARGET_LM32) || (defined(TARGET_SPARC) && !defined(TARGET_SPARC64))
>      {
>          .name       = "irq",
> 

Perhaps we can a use a "#if defined(CONFIG_I8259) ||
defined(CONFIG_LM32) || (defined(TARGE_SPARC) &&
!defined(TARGET_SPARC64))" instead, so we keep the command for PReP ?

Laurent