Re: [PATCH v3 2/2] iio: light: opt3001: Add device tree binding documentation

[Jonathan Cameron <jic23@kernel.org>]

On 02/07/15 23:27, Andreas Dannenberg wrote:
> Signed-off-by: Andreas Dannenberg <dannenberg@ti.com>
Utterly standard binding so unless someone shouts, I'll pick this
up with the driver.

Thanks,

Jonathan
> ---
>  .../devicetree/bindings/iio/light/opt3001.txt          | 18 ++++++++++++++++++
>  1 file changed, 18 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/light/opt3001.txt
> 
> diff --git a/Documentation/devicetree/bindings/iio/light/opt3001.txt b/Documentation/devicetree/bindings/iio/light/opt3001.txt
> new file mode 100644
> index 0000000..d5f0765
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/light/opt3001.txt
> @@ -0,0 +1,18 @@
> +* Texas Instruments OPT3001 Ambient Light Sensor
> +
> +http://www.ti.com/product/opt3001
> +
> +Required properties:
> +  - compatible: should be "ti,opt3001"
> +  - reg: the I2C address of the sensor
> +  - interrupt-parent: should be the phandle for the interrupt controller
> +  - interrupts: interrupt mapping for GPIO IRQ (configure for falling edge)
> +
> +Example:
> +
> +opt3001@44 {
> +	compatible = "ti,opt3001";
> +	reg = <0x44>;
> +	interrupt-parent = <&gpio1>;
> +	interrupts = <28 IRQ_TYPE_EDGE_FALLING>;
> +};
>