[PATCH 2/3] [v4] ARM64: TTY: hvc_dcc: Add support for ARM64 dcc

[timur@codeaurora.org (Timur Tabi)]

On 08/18/2015 03:21 AM, Dave Martin wrote:
>> Do you think that I need an explicit instruction to clear the upper
>> >bits?  I tried a few compiler tricks (e.g. "c && 0xff" and the
>> >like), and they had no effect.
> The in-register representation of a char permits the upper bits to be
> nonzero, so you need to convert to a register-sized type if you want
> to be able to force those bits to zero.
>
> Try: (unsigned long)(unsigned char)c or (unsigned long)c & 0xff.

I tried all those, and more, and I still always get the same thing:

   28:	38401423 	ldrb	w3, [x1],#1
   2c:	d5130503 	msr	dbgdtrrx_el0, x3

I know that ldrb will zero-extend the byte to a 32-bit word.  But I 
don't see any way to zero-extend the word into a 64-bit register.

I'm not even sure that this is necessary.  The dbgdtrrx_el0 register is 
technically only 32-bit anyway.  It looks to me like the code is already 
correct.

I could change the (c) to "(c && 0xff)" to be extra sure, but I can't 
verify that it actually works.

>> >it gives this assembly code:
>> >
>> >   28:	38401423 	ldrb	w3, [x1],#1
>> >   2c:	53001c63 	uxtb	w3, w3
>> >   30:	d5130503 	msr	dbgdtrrx_el0, x3
>> >
>> >Is this correct?  Shouldn't it be "uxtb x3, w3"?
> Check the ARM ARM for what operand combinations are allowed.  However,
> it doesn't really make any difference here because it's a general rule
> in the architecture that when an instruction's output is in a
> W-register, the upper 32 bits of the corresponding X-register are
> always zeroed anyway.

So does that mean that ldrb will zero-extend the byte to all 64 bits of x3?

-- 
Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.