From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from mail2.candelatech.com ([208.74.158.173]) by bombadil.infradead.org with esmtp (Exim 4.80.1 #2 (Red Hat Linux)) id 1ZXMDV-0001oF-MY for ath10k@lists.infradead.org; Thu, 03 Sep 2015 04:33:42 +0000 Message-ID: <55E7CD8D.7090003@candelatech.com> Date: Wed, 02 Sep 2015 21:33:17 -0700 From: Ben Greear MIME-Version: 1.0 Subject: Re: HT80 monitoring using ath10k References: <55E743F3.1060802@candelatech.com> In-Reply-To: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Transfer-Encoding: 7bit Content-Type: text/plain; charset="us-ascii"; Format="flowed" Sender: "ath10k" Errors-To: ath10k-bounces+kvalo=adurom.com@lists.infradead.org To: Yeoh Chun-Yeow Cc: "ath10k@lists.infradead.org" On 09/02/2015 08:32 PM, Yeoh Chun-Yeow wrote: > On Thu, Sep 3, 2015 at 2:46 AM, Ben Greear wrote: >> On 09/01/2015 06:20 PM, Yeoh Chun-Yeow wrote: >>> >>> Hi, all >>> >>> Anyone has able to capture the packet sent using HT80 or even higher >>> putting ath10k in monitor mode? >>> >>> Please let me know. Thanks >> >> >> I guess it would require wave-2 hardware to even have a chance of HT160? >> >> I thought HT80 capture worked fine on peregrine....I should have a chance to >> try this for some upcoming IBSS work I have scheduled for my 10.1 firmware. > > Did you ever try it before with HT80? > > I set using the following after bring up the interface: > iw moni0 set freq 5180 80 5210 > > But not seeing any data packet and just those mgmt frame. To be honest, I normally configure an AP on appropriate channels, and then just start up a monitor interface. Then, stop the AP interface. I have poor luck getting a monitor interface to reliably configure the proper channel & width on its own. Thanks, Ben -- Ben Greear Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k