Op 11-09-15 om 22:01 schreef Torbjorn Jansson:
>
> did you get it to work?
>
> i got a dvbsky T980C too for dvb-t2 reception and so far the only 
> drivers that have worked at all is the ones from dvbsky directly.
>
> i was very happy when i noticed that recent kernels have support for 
> it built in but unfortunately only the modules and firmware loads but 
> then nothing actually works.
> i use mythtv and it complains a lot about the signal, running femon 
> also produces lots of errors.
>
> so i had to switch back to kernel 4.0.4 with mediabuild from dvbsky.
>
> if there were any other dvb-t2 card with ci support that had better 
> drivers i would change right away.
>
> one problem i have with the mediabuilt from dvbsky is that at boot the 
> cam never works and i have to first tune a channel, then remove and 
> reinstert the cam to get it to work.
> without that nothing works.
>
> and finally a problem i ran into when i tried mediabuilt from 
> linuxtv.org.
> fedora uses kernel modules with .ko.xz extension so when you install 
> the mediabuilt modulels you get one modulename.ko and one modulename.ko.xz
>
> before a make install from mediabuild overwrote the needed modules.
> any advice on how to handle this now?
You could patch the Makefile with a patch from Oliver Endriss (attached).
This way all modules get installed in /lib/modules/`uname -r`/updates/media
If your kernel needs it, you can compress them afterwards.
>
>
> -- 
> To unsubscribe from this list: send the line "unsubscribe linux-media" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html