From mboxrd@z Thu Jan 1 00:00:00 1970 From: Heiko Schocher Date: Tue, 24 Nov 2015 17:10:22 +0100 Subject: [U-Boot] powerpc, tqm5200s: fails with current head Message-ID: <56548BEE.10906@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hello Simon, I just tried current mainline on the tqm5200s board, and it fails. git bisect showed: f05ad9ba4c22b5c5929406394a0889791c2778da is the first bad commit commit f05ad9ba4c22b5c5929406394a0889791c2778da Author: Simon Glass Date: Tue Aug 4 12:33:39 2015 -0600 Add a way to skip relocation When running U-Boot as an EFI application we cannot relocate since we do not have relocation information. U-Boot has already been relocated to a suitable address. Add a global_data flag to control skipping relocation. Signed-off-by: Simon Glass Reviewed-by: Bin Meng You can look into the hole git bisect session here [1] I reverted this patch, and then the board boots again [2] Do you have an idea, what can be wrong here? I try to find time to look into it. bye, Heiko [1] tbot automated git bisect session http://xeidos.ddns.net/buildbot/builders/tqm5200s/builds/3/steps/shell/logs/tbotlog [2] bootlog without commit f05ad9ba read 1: U-Boot 2016.01-rc1-00241-g71cbed3-dirty (Nov 24 2015 - 17:03:06 +0100) read 1: read 1: CPU: MPC5200B v2.2, Core v1.4 at 396 MHz read 1: Bus 132 MHz, IPB 132 MHz, PCI 66 MHz read 1: Board: TQM5200S (TQ-Components GmbH) read 1: on a STK52xx carrier board read 1: I2C: 85 kHz, ready read 1: DRAM: 64 MiB read 1: Flash: 32 MiB read 1: In: serial read 1: Out: serial read 1: Err: serial read 1: Net: FEC read 1: IDE: Bus 0: OK read 1: Device 0: Model: HITACHI_DK23DA-20 Firm: 00J2A0A1 Ser#: 12Y0MN read 1: Type: Hard Disk read 1: Capacity: 19077.1 MB = 18.6 GB (39070080 x 512) read 1: Device 1: not available read 1: SRAM: 512 kB read 1: PS/2: read 1: No device found read 1: read 1: Kbd: reset failed, no ACK read 1: read 1: Type run flash_nfs to mount root filesystem over NFS read 1: read 1: => -- DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany