Re: [PATCH v3 4/5] Documentation: afe4403: Add DT bindings for the AFE4403 heart monitor

[Jonathan Cameron <jic23@kernel.org>]

On 14/12/15 22:36, Andrew F. Davis wrote:
> Add the TI AFE4403 heart monitor DT bindings documentation.
> 
> Signed-off-by: Andrew F. Davis <afd@ti.com>
Nothing terribly controversial in here that I can spot
so looks good to me.

Jonathan
> ---
>  .../devicetree/bindings/iio/health/afe4403.txt     | 34 ++++++++++++++++++++++
>  1 file changed, 34 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/iio/health/afe4403.txt
> 
> diff --git a/Documentation/devicetree/bindings/iio/health/afe4403.txt b/Documentation/devicetree/bindings/iio/health/afe4403.txt
> new file mode 100644
> index 0000000..2fffd70
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/health/afe4403.txt
> @@ -0,0 +1,34 @@
> +Texas Instruments AFE4403 Heart rate and Pulse Oximeter
> +
> +Required properties:
> + - compatible		: Should be "ti,afe4403".
> + - reg			: SPI chip select address of device.
> + - tx-supply		: Regulator supply to transmitting LEDs.
> + - interrupt-parent	: Phandle to he parent interrupt controller.
> + - interrupts		: The interrupt line the device ADC_RDY pin is
> +			  connected to. For details refer to,
> +			  ../../interrupt-controller/interrupts.txt.
> +
> +Optional properties:
> + - reset-gpios		: GPIO used to reset the device.
> +			  For details refer to, ../../gpio/gpio.txt.
> +
> +For other required and optional properties of SPI slave nodes
> +please refer to ../../spi/spi-bus.txt.
> +
> +Example:
> +
> +&spi0 {
> +	heart_mon@0 {
> +		compatible = "ti,afe4403";
> +		reg = <0>;
> +		spi-max-frequency = <10000000>;
> +
> +		tx-supply = <&vbat>;
> +
> +		interrupt-parent = <&gpio1>;
> +		interrupts = <28 IRQ_TYPE_EDGE_RISING>;
> +
> +		reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
> +	};
> +};
>