[U-Boot] [PATCH 2/2] mx7dsabresd: Define serial port locally

[Stefano Babic <sbabic@denx.de>]

On 22/02/2016 22:41, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam@nxp.com>
> 
> CONFIG_MXC_UART_BASE should not be defined in mx7_common.h as
> the console port can vary from board to board.
> 
> Define CONFIG_MXC_UART_BASE locally instead.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
> ---
>  include/configs/mx7_common.h  | 1 -
>  include/configs/mx7dsabresd.h | 2 ++
>  2 files changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/include/configs/mx7_common.h b/include/configs/mx7_common.h
> index b2a8756..bfad696 100644
> --- a/include/configs/mx7_common.h
> +++ b/include/configs/mx7_common.h
> @@ -77,7 +77,6 @@
>  
>  /* UART */
>  #define CONFIG_MXC_UART
> -#define CONFIG_MXC_UART_BASE            UART1_IPS_BASE_ADDR
>  
>  /* MMC */
>  #define CONFIG_MMC
> diff --git a/include/configs/mx7dsabresd.h b/include/configs/mx7dsabresd.h
> index 2c981e0..b8b5b45 100644
> --- a/include/configs/mx7dsabresd.h
> +++ b/include/configs/mx7dsabresd.h
> @@ -14,6 +14,8 @@
>  #define CONFIG_DBG_MONITOR
>  #define PHYS_SDRAM_SIZE			SZ_1G
>  
> +#define CONFIG_MXC_UART_BASE            UART1_IPS_BASE_ADDR
> +
>  /* Uncomment to enable secure boot support */
>  /* #define CONFIG_SECURE_BOOT */
>  #define CONFIG_CSF_SIZE			0x4000
> 
Applied to -next, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================