Re: [Qemu-devel] [PATCH v4 00/16] IOMMU: Enable interrupt remapping for Intel IOMMU

[Paolo Bonzini <pbonzini@redhat.com>]

On 26/04/2016 09:34, Peter Xu wrote:
> +/*
> + * This is to satisfy the hack in Linux kernel. One hack of it is to
> + * simulate clearing the Remote IRR bit of IOAPIC entry using the
> + * following:
> + *
> + * "For IO-APIC's with EOI register, we use that to do an explicit EOI.
> + * Otherwise, we simulate the EOI message manually by changing the trigger
> + * mode to edge and then back to level, with RTE being masked during
> + * this."
> + *
> + * (See linux kernel __eoi_ioapic_pin() comment in commit c0205701)
> + *
> + * This is based on the assumption that, Remote IRR bit will be
> + * cleared by IOAPIC hardware for edge-triggered interrupts (I
> + * believe that's what the IOAPIC version 0x1X hardware does). So
> + * if we are emulating it, we'd better do it the same here, so that
> + * the guest kernel hack will work as well on QEMU.
> + *
> + * Without this, level-triggered interrupts in IR mode might fail to
> + * work correctly.
> + */
> +static inline void
> +ioapic_fix_edge_remote_irr(uint64_t *entry)
> +{
> +    if (*entry & IOAPIC_LVT_TRIGGER_MODE) {
> +        /* Level triggered interrupts, make sure remote IRR is zero */
> +        *entry &= ~((uint64_t)IOAPIC_LVT_REMOTE_IRR);
> +    }
> +}
> +
>  static void
>  ioapic_mem_write(void *opaque, hwaddr addr, uint64_t val,
>                   unsigned int size)
> @@ -314,6 +344,7 @@ ioapic_mem_write(void *opaque, hwaddr addr, uint64_t val,
>                      s->ioredtbl[index] &= ~0xffffffffULL;
>                      s->ioredtbl[index] |= val;
>                  }
> +                ioapic_fix_edge_remote_irr(&s->ioredtbl[index]);
>                  ioapic_service(s);
>              }
>          }

Is this enough too?

diff --git a/hw/intc/ioapic.c b/hw/intc/ioapic.c
index 378e663..2443a35 100644
--- a/hw/intc/ioapic.c
+++ b/hw/intc/ioapic.c
@@ -72,6 +72,7 @@ static void ioapic_service(IOAPICCommonState *s)
                     (entry >> IOAPIC_LVT_DELIV_MODE_SHIFT) & IOAPIC_DM_MASK;
                 if (trig_mode == IOAPIC_TRIGGER_EDGE) {
                     s->irr &= ~mask;
+                    s->ioredtbl[i] &= ~IOAPIC_LVT_REMOTE_IRR;
                 } else {
                     coalesce = s->ioredtbl[i] & IOAPIC_LVT_REMOTE_IRR;
                     s->ioredtbl[i] |= IOAPIC_LVT_REMOTE_IRR;

Thanks,

Paolo