Re: [PATCH v1 00/15] io_uring zero copy rx

[Jens Axboe <axboe@kernel.dk>]

On 10/9/24 10:35 AM, David Ahern wrote:
> On 10/9/24 9:43 AM, Jens Axboe wrote:
>> Yep basically line rate, I get 97-98Gbps. I originally used a slower box
>> as the sender, but then you're capped on the non-zc sender being too
>> slow. The intel box does better, but it's still basically maxing out the
>> sender at this point. So yeah, with a faster (or more efficient sender),
> 
> I am surprised by this comment. You should not see a Tx limited test
> (including CPU bound sender). Tx with ZC has been the easy option for a
> while now.

I just set this up to test yesterday and just used default! I'm sure
there is a zc option, just not the default and hence it wasn't used.
I'll give it a spin, will be useful for 200G testing.

>> I have no doubts this will go much higher per thread, if the link bw was
>> there. When I looked at CPU usage for the receiver, the thread itself is
>> using ~30% CPU. And then there's some softirq/irq time outside of that,
>> but that should ammortize with higher bps rates too I'd expect.
>>
>> My nic does have 2 100G ports, so might warrant a bit more testing...
>>
> 
> It would be good to see what the next bottleneck is for io_uring with ZC
> Rx path. My expectation is that a 200G link is a means to show you (ie.,
> you will not hit 200G so cpu monitoring, perf-top, etc will show the
> limiter).

I'm pretty familiar with profiling ;-)

I'll see if I can get the 200G test setup and then I'll report back what
I get.

-- 
Jens Axboe