Re: [PATCH] log: document the --decorate=auto option

[Marc Branchaud <marcnarc@xiplink.com>]

On 2016-05-27 11:56 AM, Ramsay Jones wrote:
>
> Signed-off-by: Ramsay Jones <ramsay@ramsayjones.plus.com>
> ---
>
> Hi Junio,
>
> While reading an email from Linus earlier (RFC: dynamic "auto" date formats),
> I noticed that log.decorate was being set to 'auto'. Since I didn't recall
> that setting (even if it's easy to guess), I went looking for the documentation ...
>
> This should probably be marked RFC, since I haven't checked that the formatting
> is OK (I don't have the documentation toolchain installed these days).
>
> ATB,
> Ramsay Jones
>
>   Documentation/config.txt  | 5 ++++-
>   Documentation/git-log.txt | 8 +++++---
>   2 files changed, 9 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/config.txt b/Documentation/config.txt
> index 53f00db..0707b3b 100644
> --- a/Documentation/config.txt
> +++ b/Documentation/config.txt
> @@ -1956,7 +1956,10 @@ log.decorate::
>   	command. If 'short' is specified, the ref name prefixes 'refs/heads/',
>   	'refs/tags/' and 'refs/remotes/' will not be printed. If 'full' is
>   	specified, the full ref name (including prefix) will be printed.
> -	This is the same as the log commands '--decorate' option.
> +	If 'auto' is specified, then if the output is going to a terminal,
> +	the ref names are shown as if 'short' were given, otherwise no ref
> +	names are shown. This is the same as the log commands '--decorate'

s/commands/command's/

		M.