Re: [PATCH] mmc: core: fix the wrong error control

[Jaehoon Chung <jh80.chung@samsung.com>]

On 05/30/2016 06:45 PM, Shawn Lin wrote:
> Hi,
> 
> 在 2016/5/30 15:40, Jaehoon Chung 写道:
>> After applied "remove lots of IS_ERR_VALUE abuses", it shoold be
>> misoperation. (commit 287980e49)
>> If mmc_bus_test is successful, it returned the bus-witdh bit.
>>
>> The below log is error log
>> [    2.542260] mmc0: mmc_select_hs200 failed, error 3
>> [    2.542275] mmc0: error 3 whilst initialising MMC card
>>
> 
> The same as this patch[0]?

Yes, discard this patch. Thanks for noticing this.

Best Regards,
Jaehoon Chung

> 
> [0]https://patchwork.kernel.org/patch/9139673/
> 
>> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com>
>> ---
>>  drivers/mmc/core/mmc.c | 4 ++--
>>  1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
>> index c984321..aafb73d 100644
>> --- a/drivers/mmc/core/mmc.c
>> +++ b/drivers/mmc/core/mmc.c
>> @@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card)
>>       * switch to HS200 mode if bus width is set successfully.
>>       */
>>      err = mmc_select_bus_width(card);
>> -    if (!err) {
>> +    if (err > 0) {
>>          val = EXT_CSD_TIMING_HS200 |
>>                card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
>>          err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
>> @@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
>>      } else if (mmc_card_hs(card)) {
>>          /* Select the desired bus width optionally */
>>          err = mmc_select_bus_width(card);
>> -        if (!err) {
>> +        if (err > 0) {
>>              err = mmc_select_hs_ddr(card);
>>              if (err)
>>                  goto free_card;
>>
> 
> -- 
> To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> 
> 
>