Hello Zhenhua,

Thank you for confirming that.  I will stick to using the code supplied in the SDK which seems to contain Yocto 1.6.1 daisy.  I'll make sure to reference documents relating to that version 1.6 Yocto and the corresponding Poky 11.0 version.  

Thomas Thorne  Software Engineer  Net2Edge Limited
On 14/07/16 12:43, Zhenhua Luo wrote:

Hello Tom,

 

The meta-fsl-arm layer in Yocto git repo only supports ls1021atwr. To support ls1021a-iot board, you should use the SDK in the NXP official website.

 

 

Best Regards,

 

Zhenhua

 

From: meta-freescale-bounces@yoctoproject.org [mailto:meta-freescale-bounces@yoctoproject.org] On Behalf Of Thomas A. F. Thorne MEng AUS MIET
Sent: Thursday, July 14, 2016 12:34 AM
To: meta-freescale@yoctoproject.org
Subject: [meta-freescale] Which is the correct BSP to use for a freescale LS1021A-IOT development kit?

 

Good afternoon,

I have a freescale LS1021A-IOT development board and was wondering if the meta-fsl-arm layer was the correct board support package for it?  I can see the ls1021atwr.conf in  meta-fsl-arm/conf/machine/ which targets the ls102xa chipset so it seems likely to be the correct one. 

What makes me wonder if it the correct one is that there is a dedicated ls1021aiot.conf in the meta-fsl-arm layer provided by the LS1021A-IOT SDK found at http://www.nxp.com/products/microcontrollers-and-processors/arm-processors/qoriq-arm-processors/qoriq-ls1021a-iot-gateway-reference-design:LS1021A-IoT?fpsp=1&tab=Design_Tools_Tab

Regards, Tom

-- 
Thomas Thorne  Software Engineer  Net2Edge Limited