From mboxrd@z Thu Jan  1 00:00:00 1970
From: Heiko Schocher <hs@denx.de>
Date: Mon, 25 Jul 2016 19:24:06 +0200
Subject: [U-Boot] a few questions about saving bootcount in the
 environment
In-Reply-To: <20160725132628.09B06100A6B@atlas.denx.de>
References: <alpine.LFD.2.20.1607221529190.7337@localhost.localdomain>
 <20160722220136.5F967100539@atlas.denx.de>
 <alpine.LFD.2.20.1607230737010.12216@localhost.localdomain>
 <20160725045452.5990E100539@atlas.denx.de>
 <alpine.LFD.2.20.1607250558110.24069@localhost.localdomain>
 <20160725132628.09B06100A6B@atlas.denx.de>
Message-ID: <57964B36.9080002@denx.de>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="us-ascii"
Content-Transfer-Encoding: 7bit
To: u-boot@lists.denx.de

Hello Wolfgang,

Am 25.07.2016 um 15:26 schrieb Wolfgang Denk:
> Dear Robert,
>
> In message <alpine.LFD.2.20.1607250558110.24069@localhost.localdomain> you wrote:
>>
>>    i'm not sure it's as bad as it looks, since those macros are used
>> specifically in drivers/bootcount/Makefile:
>
> You are right, and apparently it is working fine so far.  But it is
> confusing, and...
>
>>    obj-$(CONFIG_SOC_DA8XX)         += bootcount_davinci.o
>>    obj-$(CONFIG_BOOTCOUNT_AM33XX)  += bootcount_davinci.o
>
> ..this would make more sense to me if it was called
>
> 	CONFIG_BOOTCOUNT_DAVINCI

Yep, correct!

bye,
Heiko
-- 
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany