Re: [PATCH] [v6] net: emac: emac gigabit ethernet controller driver

[Timur Tabi <timur@codeaurora.org>]

Arnd Bergmann wrote:
> This is basically ok, but then I think you should pass GFP_DMA
> or GFP_DMA32 to all allocations that the driver does after
> the 64-bit mask fails, otherwise you get a significant overhead
> in the bounce buffers.

Well, for starters, ZONE_DMA32 is the same as ZONE_NORMAL on ARM, 
because CONFIG_ZONE_DMA32 is not defined.

#ifdef CONFIG_ZONE_DMA32
#define OPT_ZONE_DMA32 ZONE_DMA32
#else
#define OPT_ZONE_DMA32 ZONE_NORMAL
#endif

(I wonder if this should say instead:

#ifdef CONFIG_ZONE_DMA32
#define OPT_ZONE_DMA32 ZONE_DMA32
#else
#define OPT_ZONE_DMA32 ZONE_DMA  <----
#endif
)

However, I'm not sure where I should be using GFP_DMA anyway.  Whenever 
the driver allocates memory for DMA, it uses dma_zalloc_coherent():

ring_header->v_addr = dma_zalloc_coherent(dev, ring_header->size,
					 &ring_header->dma_addr,
					 GFP_KERNEL);

and I don't think I need to pass GFP_DMA to dma_zalloc_coherent.  Every 
other memory allocation is a kmalloc variant, but that's never for DMA, 
so that memory can be anywhere.

I found about 70 drivers that fall-back to 32-bit DMA if 64-bit fails. 
None of them do as you suggest.  They all just set the mask to 64 or 32 
and that's it.

Some drivers set NETIF_F_HIGHDMA if 64-bit DMA is enabled:

	if (pci_using_dac)
		netdev->features |= NETIF_F_HIGHDMA;

I could do this, but I think it has no meaning on ARM64 because it 
depends on CONFIG_HIGHMEM.

-- 
Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm
Technologies, Inc.  Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.