Re: i found time delay is very high and there are more caution info , if possible , please give me some advisement

[johnzeng <johnzeng2013@yahoo.com>]

Hello Dear Sven and Linus:

                                             You are right , and When i 
check /sys/class/net/bat0/mesh/*   and i found  archlinux lost 
network-coding .

                            They were connected via a single cable as you .

                            Whether i need use older batman version (batman-adv and batctl 2015.2 ) ?

                            and our version is newest version ( Linux alarmpi 4.4.26-1-ARCH ) and hardware platform is raspberry pi B , but

                            i search wiki , i found kernel 4.4 will usebatman 2015.2

                            https://www.open-mesh.org/projects/open-mesh/wiki/Download

                            linux 4.4 => batman-adv 2015.2 (get batctl 2015.2 fromhere  <https://downloads.open-mesh.org/batman/stable/sources/batctl/>).


                                if batman-adv don't support archlinux really , whether ubuntu will support batman-adv .




                                Thanks


                                



[root@alarmpi ~]# grep '' /sys/class/net/bat0/mesh/*
/sys/class/net/bat0/mesh/aggregated_ogms:enabled
/sys/class/net/bat0/mesh/ap_isolation:disabled
/sys/class/net/bat0/mesh/bonding:disabled
/sys/class/net/bat0/mesh/bridge_loop_avoidance:enabled
/sys/class/net/bat0/mesh/distributed_arp_table:enabled
/sys/class/net/bat0/mesh/fragmentation:enabled
/sys/class/net/bat0/mesh/gw_bandwidth:10.0/2.0 MBit
/sys/class/net/bat0/mesh/gw_mode:off
/sys/class/net/bat0/mesh/gw_sel_class:20
/sys/class/net/bat0/mesh/hop_penalty:30
/sys/class/net/bat0/mesh/isolation_mark:0x00000000/0x00000000
/sys/class/net/bat0/mesh/multicast_mode:enabled
/sys/class/net/bat0/mesh/orig_interval:1000
/sys/class/net/bat0/mesh/routing_algo:BATMAN_IV