Re: 8272ADS and Linux 2.6.12

[SIP COP 009 <sipcop009@gmail.com>]

Here's my serial config..., also these dont show up if i just=20
run "make ads8272_defconfig". I have to explicitly go and enable the
serial options.


#
# Serial drivers
#
CONFIG_SERIAL_8250=3Dy
CONFIG_SERIAL_8250_CONSOLE=3Dy
CONFIG_SERIAL_8250_NR_UARTS=3D4
# CONFIG_SERIAL_8250_EXTENDED is not set

#
# Non-8250 serial port support
#
CONFIG_SERIAL_CORE=3Dy
CONFIG_SERIAL_CORE_CONSOLE=3Dy
# CONFIG_SERIAL_CPM is not set
# CONFIG_SERIAL_JSM is not set
CONFIG_UNIX98_PTYS=3Dy
CONFIG_LEGACY_PTYS=3Dy
CONFIG_LEGACY_PTY_COUNT=3D256

Thanks!
ashutosh

On 7/14/05, Allen Curtis <acurtis@onz.com> wrote:
> > =3D> setenv bootargs console=3DttyCPM0,115200  root=3D/dev/ram
> > =3D> bootm fe600000
> > ## Booting image at fe600000 ...
> >    Image Name:   2.6.12 for 8272
> >    Image Type:   PowerPC Linux Kernel Image (gzip compressed)
> >    Data Size:    875845 Bytes =3D 855.3 kB
> >    Load Address: 00000000
> >    Entry Point:  00000000
> >    Verifying Checksum ... OK
> >    Uncompressing Kernel Image ... OK
> >
>=20
> Can you provide your kernel configuration information regarding the
> serial ports. Which serial port is your console port? Check the
> following configuration options:
>   CONFIG_SERIAL_CONSOLE
>   CONFIG_SCC_CONSOLE
>   CONFIG_SERIAL_CORE
>   CONFIG_SERIAL_CORE_CONSOLE
>=20
> Another observation is that you are trying to boot with a RAM disk but
> you have not provided the RAM disk address to the bootm command. This
> is not your current problem since you don't get that far.
>=20
> - Allen
>=20
>