From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bugzilla-Redirect Date: Sat, 16 Sep 2006 01:38:36 +0000 Subject: Re: [LARTC] Re: htb traffic shaping problem Message-Id: <6.2.0.14.2.20060915193530.02eaf330@linux.sysreset.com> List-Id: References: <6.2.0.14.2.20060912225307.02dd8f98@linux.sysreset.com> In-Reply-To: <6.2.0.14.2.20060912225307.02dd8f98@linux.sysreset.com> MIME-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable To: lartc@vger.kernel.org Yes, the output is below: eth0 Link encap:Ethernet HWaddr 00:11:09:2A:A6:F6 inet addr:10.0.0.50 Bcast:10.0.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:4244867 errors:0 dropped:0 overruns:0 frame:0 TX packets:1306632 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:3898905509 (3.6 GiB) TX bytes:1756030081 (1.6 GiB) Interrupt:19 And from ethtool: Settings for eth0: Supported ports: [ MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Advertised auto-negotiation: Yes Speed: 1000Mb/s Duplex: Full Port: MII PHYAD: 1 Transceiver: external Auto-negotiation: on Supports Wake-on: g Wake-on: d Link detected: yes Thanks. -Ryan Power At 04:32 PM 9/14/2006, you wrote: >Hi, > >could you check the mtu set on eth0 with an ifconfig? >I tried my own setup and it works fine... > > >Regards, > >Eric Janz >Departamento de Sistemas >Grupo Barcel=F3 Viajes _______________________________________________ LARTC mailing list LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc