From mboxrd@z Thu Jan 1 00:00:00 1970 From: Chuck Hast Subject: Re: Trying to get Ax25 running. Date: Fri, 15 Oct 2004 09:57:06 -0700 Sender: linux-hams-owner@vger.kernel.org Message-ID: <620c9057041015095771b236e0@mail.gmail.com> References: <620c9057041013094421cbf279@mail.gmail.com> <20041014025505.66938.qmail@web40824.mail.yahoo.com> <620c9057041014060070eeccf6@mail.gmail.com> <200410141313.i9EDDoah001022@yagi.h-net.msu.edu> Reply-To: Chuck Hast Mime-Version: 1.0 Content-Transfer-Encoding: 7bit Return-path: In-Reply-To: <200410141313.i9EDDoah001022@yagi.h-net.msu.edu> List-Id: Content-Type: text/plain; charset="us-ascii" To: linux-hams@vger.kernel.org Folks, I have used the AX25 config tool to configure this stuff. I am trying to set up things to run mkiss, but I can not quite figure out where to put the -c so that mkiss will use the crc check. ax25-config tool does not ask for it, so I assume that the author did not get that far down the road, but when I look in the files it creates I do not see the mkiss line anywhere, I do see where it does a modprobe for ax25,kiss and mkiss, the one that is installed when I do a lsmod is mkiss. So now if I can just figure out where the mkiss configuration line is stuck I should be able to set it up to use the crc check on the kiss frames. On our DOS FPAC switches we are using BPQ KISS eproms with the CRC, so in order to not have to redo all of the eproms I am just trying to get the crc check running, the man page on mkiss says that the -c parm will cause it to do crc.