Re: [PATCH v2 bpf-next 4/6] selftests/bpf: Add IPv4 and IPv6 sockaddr test cases

[Martin KaFai Lau <martin.lau@linux.dev>]

On 4/28/24 10:47 AM, Jordan Rife wrote:
>> Also, all this setup (and test) has to be done in a new netns. Anything blocking
>> the kfunc in patch 2 using the current task netns instead of the init_net?
>> Add nodad to the "ip -6 addr add...". just in case it may add unnecessary delay.
>> This interface/address ping should not be needed. Other tests under prog_tests/
>> don't need this interface/address ping also.
> 
> I was able to make these changes.
> 
>> Does it need a veth pair? The %s2 interface is not used.
>>
>> Can it be done in lo alone?
> 
> I think it may be better to keep it as-is for now with the veth pair.
> It turns out that these BPF programs (progs/bind6_prog.c,
> progs/bind4_prog.c, and progs/connect4_prog.c) expect the veth pair
> setup with these names (test_sock_addr1, test_sock_addr2). We may be
> able to update the logic in these BPF programs to allow us to just use
> lo, but I'm not sure if we'd be losing out on important test coverage.
> Additionally, since we aren't fully retiring test_sock_addr.c yet we'd
> also need to change test_sock_addr.sh if we changed
> progs/bind6_prog.c, progs/bind4_prog.c, and progs/connect4_prog.c. If
> there are no objections to leaving things as-is here, I will send out
> v3 with the rest of the changes listed above.

Yep, the veth cleanup could be done when the test_sock_addr.c is fully retired. 
Thanks for checking.

For the tests that moved to sock_addr.c, please also remove them from 
test_sock_addr.c.