From mboxrd@z Thu Jan 1 00:00:00 1970 From: Dinh Nguyen Date: Tue, 10 Apr 2018 13:56:58 -0500 Subject: [U-Boot] arm: socfpga: unable to boot cyclone5 devkit or SocKit In-Reply-To: References: <75271d91-491c-e0ab-543a-0dbf631d903e@kernel.org> Message-ID: <6a21b85b-6b05-ae5a-0077-eaf39689b500@kernel.org> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 04/10/2018 01:29 PM, Marek Vasut wrote: > On 04/10/2018 08:28 PM, Dinh Nguyen wrote: >> Hi, >> >> I'm seeking advice with an observation that I'm seeing on the Cyclone5 >> devkit/sockit. >> >> I'm working with U-Boot version v2018.05-rc1. Building the >> u-boot-with-spl.sfp, then writing the sfp file to the 0xa2 partition on >> the SD card, does not boot, all I get is this: >> >> U-Boot SPL 2018.05-rc1 (Apr 10 2018 - 13:03:48 -0500) >> >> U-Boot SPL 2018.05-rc1 (Apr 10 2018 - 13:03:48 -0500) >> >> U-Boot SPL 2018.05-rc1 (Apr 10 2018 - 13:03:48 -0500) >> >> >> This issue doesn't happen at all on the DE0 Nano SoC board. I compared >> the defconfig and came across this. If I remove these config options in >> the socfpga_sockit_defconfig, then SPL -> U-Boot works fine. >> >> -CONFIG_SPI_FLASH_MACRONIX=y >> -CONFIG_SPI_FLASH_SPANSION=y >> -CONFIG_SPI_FLASH_STMICRO=y >> >> I'll continue to debug of course, but was wondering if anyone might have >> a better idea as to what could be happening, I'd appreciate the insight. > > Check the size of the SPL , could it be too big ? > That's a good thought...it could be. The size of the default u-boot-spl-dtb.bin is 58048, removing the SPI, brings that down to 55616, that's smaller than the 64k of OCRAM for SPL? Dinh