From: Bhaumik Bhatt <bbhatt@codeaurora.org>
To: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Cc: linux-arm-msm@vger.kernel.org, hemantk@codeaurora.org,
jhugo@codeaurora.org, linux-kernel@vger.kernel.org,
carl.yin@quectel.com, naveen.kumar@quectel.com,
loic.poulain@linaro.org, abickett@codeaurora.org
Subject: Re: [PATCH v1 0/7] MHI Emergency download and flash programmer support
Date: Wed, 31 Mar 2021 10:01:04 -0700 [thread overview]
Message-ID: <6fcd439aa759d8cbc9bab1862d1d9a57@codeaurora.org> (raw)
In-Reply-To: <20210331111644.GE15610@work>
Hi Mani,
On 2021-03-31 04:16 AM, Manivannan Sadhasivam wrote:
> On Mon, Mar 29, 2021 at 06:28:17PM -0700, Bhaumik Bhatt wrote:
>> Allow handling EDL mode after SYS_ERROR occurs by reading the
>> execution
>> environment post handling and move to power on reset state to
>> accommodate the
>> scenario.
>> Handle EDL mode properly and wait for ready instead of just exiting
>> from the
>> firmware load.
>> Allow use of the Flash Programmer execution environment as a mission
>> mode
>> use case for a blank NAND power up scenario.
>> Always attempt a wait for MHI ready state as device could be waiting
>> for the
>> host to do so after pass through execution environment is seen.
>> Introduce patch to improve state awareness and aid in debugging.
>>
>> This patch series was tested on x86_64 architecture.
>>
>
> These patches were part of a different series before. It is good that
> you splitted the patches but you should mention that here.
>
> Thanks,
> Mani
>
I will keep that in mind when submitting next time.
>> Bhaumik Bhatt (6):
>> bus: mhi: core: Rely on accurate method to determine EDL mode
>> bus: mhi: core: Wait for ready after an EDL firmware download
>> bus: mhi: core: Handle EDL mode entry appropriately
>> bus: mhi: core: Identify Flash Programmer as a mission mode use case
>> bus: mhi: core: Wait for MHI READY state in most scenarios
>> bus: mhi: core: Improve state strings for debug messages
>>
>> Carl Yin (1):
>> bus: mhi: core: Add support for Flash Programmer execution
>> environment
>>
>> drivers/bus/mhi/core/boot.c | 13 +++++++------
>> drivers/bus/mhi/core/init.c | 34
>> ++++++++++++++++++----------------
>> drivers/bus/mhi/core/internal.h | 4 +++-
>> drivers/bus/mhi/core/main.c | 3 +++
>> drivers/bus/mhi/core/pm.c | 28 +++++++++++++++++++++++++---
>> include/linux/mhi.h | 4 +++-
>> 6 files changed, 59 insertions(+), 27 deletions(-)
>>
>> --
>> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
>> Forum,
>> a Linux Foundation Collaborative Project
>>
Thanks,
Bhaumik
---
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora
Forum,
a Linux Foundation Collaborative Project
next prev parent reply other threads:[~2021-03-31 17:02 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-03-30 1:28 [PATCH v1 0/7] MHI Emergency download and flash programmer support Bhaumik Bhatt
2021-03-30 1:28 ` [PATCH v1 1/7] bus: mhi: core: Rely on accurate method to determine EDL mode Bhaumik Bhatt
2021-03-30 8:00 ` Loic Poulain
2021-03-30 1:28 ` [PATCH v1 2/7] bus: mhi: core: Wait for ready after an EDL firmware download Bhaumik Bhatt
2021-03-30 8:01 ` Loic Poulain
2021-03-30 1:28 ` [PATCH v1 3/7] bus: mhi: core: Handle EDL mode entry appropriately Bhaumik Bhatt
2021-03-30 8:01 ` Loic Poulain
2021-03-31 10:59 ` Manivannan Sadhasivam
2021-03-30 1:28 ` [PATCH v1 4/7] bus: mhi: core: Add support for Flash Programmer execution environment Bhaumik Bhatt
2021-03-30 8:02 ` Loic Poulain
2021-03-31 11:11 ` Manivannan Sadhasivam
2021-03-30 1:28 ` [PATCH v1 5/7] bus: mhi: core: Identify Flash Programmer as a mission mode use case Bhaumik Bhatt
2021-03-30 8:02 ` Loic Poulain
2021-03-30 1:28 ` [PATCH v1 6/7] bus: mhi: core: Wait for MHI READY state in most scenarios Bhaumik Bhatt
2021-03-30 8:03 ` Loic Poulain
2021-03-31 11:13 ` Manivannan Sadhasivam
2021-03-30 1:28 ` [PATCH v1 7/7] bus: mhi: core: Improve state strings for debug messages Bhaumik Bhatt
2021-03-30 8:03 ` Loic Poulain
2021-03-31 11:16 ` [PATCH v1 0/7] MHI Emergency download and flash programmer support Manivannan Sadhasivam
2021-03-31 17:01 ` Bhaumik Bhatt [this message]
2021-03-31 11:24 ` Manivannan Sadhasivam
2021-05-26 19:03 ` patchwork-bot+linux-arm-msm
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=6fcd439aa759d8cbc9bab1862d1d9a57@codeaurora.org \
--to=bbhatt@codeaurora.org \
--cc=abickett@codeaurora.org \
--cc=carl.yin@quectel.com \
--cc=hemantk@codeaurora.org \
--cc=jhugo@codeaurora.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=loic.poulain@linaro.org \
--cc=manivannan.sadhasivam@linaro.org \
--cc=naveen.kumar@quectel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.