Re: Panic:: handle_irq_event_percpu

[Sander Eikelenboom <linux@eikelenboom.it>]

Hello Wei,

Result is that using only "1" or "1" in combination with "2" always result in SATA I/O errors, so that doesn't boot.

Haven't tried rebooting a lot of times without iommu yet.
(the reason i bought the 890fx board in the first place)
Will try that a few times when i have some more time.

--
Sander

Wednesday, October 19, 2011, 6:38:38 PM, you wrote:

> It looks similar. 

> Hi Sander, could you please test your system with the following options?

> 1. iommu=amd-iommu-perdev-intremap in xen.gz GRUB entry
> 2. pci=nosmi in pvops GRUB entry
> 3. iommu=0 in xen.gz GRUB entry [optional, only if (1) doesn't work for you]

> We were seeing an issue which was caused by messed-up interrupt remap table. George Dunlap's perdev interrupt map solved our problem.

> Thanks,
> -Wei

> -----Original Message-----
> From: Konrad Rzeszutek Wilk [mailto:konrad.wilk@oracle.com] 
> Sent: Wednesday, October 19, 2011 11:08 AM
> To: Sander Eikelenboom; Huang2, Wei
> Cc: xen-devel@lists.xensource.com
> Subject: Re: [Xen-devel] Panic:: handle_irq_event_percpu

> On Tue, Oct 18, 2011 at 08:55:19PM +0200, Sander Eikelenboom wrote:
>> Hi Konrad,
>> 
>> On my system (AND phenom x6, 8gb mem) running xen 4.1.2-rc3
>> and a custom kernel based on:
>> 
>> - your linux-next branch
>> - pulled in your apci/cpufreq branch
>> - pulled in latest patches from linuses tree

> Wei,
> Are those similar to what you had been seeing?

>> 
>> I'm experiencing infrequent panics at boot (say 1 out of 10 or 20 boots), doesn't seem to matter if it's a cold or a warm boot.
>> It always seem to happen during or shortly after booting. When it doesn't occur then, it can run for at least several days/weeks (haven't seen it panic then).
>> It doesn't seem to happen at a particular point at or shortly after booting, but it happens before starting any guests
>> 
>> Unfortunately i haven't had serial console enabled at these times, but i have made some photo's.
>> The first 3 times it locked completely before being able to print a stacktrace, the 4th time it did (although the photo is a bit unsharp).
>> 
>> 
>> So all in all, it kind of strange, i hope you can figure something out from the stacktrace, if not, i will see if i can try with serial console attached.
>> 
>> --
>> Sander





>> _______________________________________________
>> Xen-devel mailing list
>> Xen-devel@lists.xensource.com
>> http://lists.xensource.com/xen-devel






-- 
Best regards,
 Sander                            mailto:linux@eikelenboom.it