RE: [PATCH v2 1/1] gpio-f7188x: fix chip name and pin count on Nuvoton chip

["Wu, Xing Tong" <XingTong.Wu@siemens.com>]

Hi all

The chip id of NCT6116D is 0XD281, you can refer to NCT6116D_Datasheet_V1_0.pdf, Page 291

BRS
Xing Tong Wu

-----Original Message-----
From: Simon Guinot <simon.guinot@sequanux.org> 
Sent: Friday, April 28, 2023 4:18 PM
To: Schild, Henning (T CED SES-DE) <henning.schild@siemens.com>
Cc: Linus Walleij <linus.walleij@linaro.org>; Bartosz Golaszewski <brgl@bgdev.pl>; linux-gpio@vger.kernel.org; linux-kernel@vger.kernel.org; Hans de Goede <hdegoede@redhat.com>; Andy Shevchenko <andriy.shevchenko@linux.intel.com>; Wu, Xing Tong (DI FA CTR IPC CN PRC4) <XingTong.Wu@siemens.com>
Subject: Re: [PATCH v2 1/1] gpio-f7188x: fix chip name and pin count on Nuvoton chip

On Thu, Apr 27, 2023 at 05:20:55PM +0200, Henning Schild wrote:
> In fact the device with chip id 0xD283 is called NCT6126D, and that is 
> the chip id the Nuvoton code was written for. Correct that name to 
> avoid confusion, because a NCT6116D in fact exists as well but has 
> another chip id, and is currently not supported.
> 
> The look at the spec also revealed that GPIO group7 in fact has 8 
> pins, so correct the pin count in that group as well.
> 
> Fixes: d0918a84aff0 ("gpio-f7188x: Add GPIO support for Nuvoton 
> NCT6116")
> Reported-by: Xing Tong Wu <xingtong.wu@siemens.com>
> Signed-off-by: Henning Schild <henning.schild@siemens.com>

Acked-by: Simon Guinot <simon.guinot@sequanux.org>

> ---
>  drivers/gpio/Kconfig       |  2 +-
>  drivers/gpio/gpio-f7188x.c | 28 ++++++++++++++--------------
>  2 files changed, 15 insertions(+), 15 deletions(-)
> 
> diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 
> badbe0582318..14b655411aa0 100644
> --- a/drivers/gpio/Kconfig
> +++ b/drivers/gpio/Kconfig
> @@ -879,7 +879,7 @@ config GPIO_F7188X
>  	help
>  	  This option enables support for GPIOs found on Fintek Super-I/O
>  	  chips F71869, F71869A, F71882FG, F71889F and F81866.
> -	  As well as Nuvoton Super-I/O chip NCT6116D.
> +	  As well as Nuvoton Super-I/O chip NCT6126D.
>  
>  	  To compile this driver as a module, choose M here: the module will
>  	  be called f7188x-gpio.
> diff --git a/drivers/gpio/gpio-f7188x.c b/drivers/gpio/gpio-f7188x.c 
> index 9effa7769bef..f54ca5a1775e 100644
> --- a/drivers/gpio/gpio-f7188x.c
> +++ b/drivers/gpio/gpio-f7188x.c
> @@ -48,7 +48,7 @@
>  /*
>   * Nuvoton devices.
>   */
> -#define SIO_NCT6116D_ID		0xD283  /* NCT6116D chipset ID */
> +#define SIO_NCT6126D_ID		0xD283  /* NCT6126D chipset ID */
>  
>  #define SIO_LD_GPIO_NUVOTON	0x07	/* GPIO logical device */
>  
> @@ -62,7 +62,7 @@ enum chips {
>  	f81866,
>  	f81804,
>  	f81865,
> -	nct6116d,
> +	nct6126d,
>  };
>  
>  static const char * const f7188x_names[] = { @@ -74,7 +74,7 @@ static 
> const char * const f7188x_names[] = {
>  	"f81866",
>  	"f81804",
>  	"f81865",
> -	"nct6116d",
> +	"nct6126d",
>  };
>  
>  struct f7188x_sio {
> @@ -187,8 +187,8 @@ static int f7188x_gpio_set_config(struct gpio_chip 
> *chip, unsigned offset,
>  /* Output mode register (0:open drain 1:push-pull). */  #define 
> f7188x_gpio_out_mode(base) ((base) + 3)
>  
> -#define f7188x_gpio_dir_invert(type)	((type) == nct6116d)
> -#define f7188x_gpio_data_single(type)	((type) == nct6116d)
> +#define f7188x_gpio_dir_invert(type)	((type) == nct6126d)
> +#define f7188x_gpio_data_single(type)	((type) == nct6126d)
>  
>  static struct f7188x_gpio_bank f71869_gpio_bank[] = {
>  	F7188X_GPIO_BANK(0, 6, 0xF0, DRVNAME "-0"), @@ -274,7 +274,7 @@ 
> static struct f7188x_gpio_bank f81865_gpio_bank[] = {
>  	F7188X_GPIO_BANK(60, 5, 0x90, DRVNAME "-6"),  };
>  
> -static struct f7188x_gpio_bank nct6116d_gpio_bank[] = {
> +static struct f7188x_gpio_bank nct6126d_gpio_bank[] = {
>  	F7188X_GPIO_BANK(0, 8, 0xE0, DRVNAME "-0"),
>  	F7188X_GPIO_BANK(10, 8, 0xE4, DRVNAME "-1"),
>  	F7188X_GPIO_BANK(20, 8, 0xE8, DRVNAME "-2"), @@ -282,7 +282,7 @@ 
> static struct f7188x_gpio_bank nct6116d_gpio_bank[] = {
>  	F7188X_GPIO_BANK(40, 8, 0xF0, DRVNAME "-4"),
>  	F7188X_GPIO_BANK(50, 8, 0xF4, DRVNAME "-5"),
>  	F7188X_GPIO_BANK(60, 8, 0xF8, DRVNAME "-6"),
> -	F7188X_GPIO_BANK(70, 1, 0xFC, DRVNAME "-7"),
> +	F7188X_GPIO_BANK(70, 8, 0xFC, DRVNAME "-7"),
>  };
>  
>  static int f7188x_gpio_get_direction(struct gpio_chip *chip, unsigned 
> offset) @@ -490,9 +490,9 @@ static int f7188x_gpio_probe(struct platform_device *pdev)
>  		data->nr_bank = ARRAY_SIZE(f81865_gpio_bank);
>  		data->bank = f81865_gpio_bank;
>  		break;
> -	case nct6116d:
> -		data->nr_bank = ARRAY_SIZE(nct6116d_gpio_bank);
> -		data->bank = nct6116d_gpio_bank;
> +	case nct6126d:
> +		data->nr_bank = ARRAY_SIZE(nct6126d_gpio_bank);
> +		data->bank = nct6126d_gpio_bank;
>  		break;
>  	default:
>  		return -ENODEV;
> @@ -559,9 +559,9 @@ static int __init f7188x_find(int addr, struct f7188x_sio *sio)
>  	case SIO_F81865_ID:
>  		sio->type = f81865;
>  		break;
> -	case SIO_NCT6116D_ID:
> +	case SIO_NCT6126D_ID:
>  		sio->device = SIO_LD_GPIO_NUVOTON;
> -		sio->type = nct6116d;
> +		sio->type = nct6126d;
>  		break;
>  	default:
>  		pr_info("Unsupported Fintek device 0x%04x\n", devid); @@ -569,7 
> +569,7 @@ static int __init f7188x_find(int addr, struct f7188x_sio *sio)
>  	}
>  
>  	/* double check manufacturer where possible */
> -	if (sio->type != nct6116d) {
> +	if (sio->type != nct6126d) {
>  		manid = superio_inw(addr, SIO_FINTEK_MANID);
>  		if (manid != SIO_FINTEK_ID) {
>  			pr_debug("Not a Fintek device at 0x%08x\n", addr); @@ -581,7 
> +581,7 @@ static int __init f7188x_find(int addr, struct f7188x_sio *sio)
>  	err = 0;
>  
>  	pr_info("Found %s at %#x\n", f7188x_names[sio->type], (unsigned int)addr);
> -	if (sio->type != nct6116d)
> +	if (sio->type != nct6126d)
>  		pr_info("   revision %d\n", superio_inb(addr, SIO_FINTEK_DEVREV));
>  
>  err:
> --
> 2.39.2