Re: [PATCH] Revert "mm: add nodes= arg to memory.reclaim"

[Bagas Sanjaya <bagasdotme@gmail.com>]

On 12/16/22 16:54, Michal Hocko wrote:
> diff --git a/Documentation/admin-guide/cgroup-v2.rst b/Documentation/admin-guide/cgroup-v2.rst
> index c8ae7c897f14..74cec76be9f2 100644
> --- a/Documentation/admin-guide/cgroup-v2.rst
> +++ b/Documentation/admin-guide/cgroup-v2.rst
> @@ -1245,13 +1245,17 @@ PAGE_SIZE multiple when read back.
>  	This is a simple interface to trigger memory reclaim in the
>  	target cgroup.
>  
> -	This file accepts a string which contains the number of bytes to
> -	reclaim.
> +	This file accepts a single key, the number of bytes to reclaim.
> +	No nested keys are currently supported.
>  
>  	Example::
>  
>  	  echo "1G" > memory.reclaim
>  
> +	The interface can be later extended with nested keys to
> +	configure the reclaim behavior. For example, specify the
> +	type of memory to reclaim from (anon, file, ..).
> +
>  	Please note that the kernel can over or under reclaim from
>  	the target cgroup. If less bytes are reclaimed than the
>  	specified amount, -EAGAIN is returned.
> @@ -1263,13 +1267,6 @@ PAGE_SIZE multiple when read back.
>  	This means that the networking layer will not adapt based on
>  	reclaim induced by memory.reclaim.
>  
> -	This file also allows the user to specify the nodes to reclaim from,
> -	via the 'nodes=' key, for example::
> -
> -	  echo "1G nodes=0,1" > memory.reclaim
> -
> -	The above instructs the kernel to reclaim memory from nodes 0,1.
> -
>    memory.peak
>  	A read-only single value file which exists on non-root
>  	cgroups.

Ah! I forgot to add my Reviewed-by: tag when the original patch was
submitted. However, I was Cc'ed the revert presumably due to Cc: tag in the
original.

In any case, for the documentation part:

Acked-by: Bagas Sanjaya <bagasdotme@gmail.com>

-- 
An old man doll... just what I always wanted! - Clara