[U-Boot-Users] [PATCH 1/4][RFC] Add initial high speed support to USB code.

["Markus Klotzbücher" <mk@denx.de>]

Hi Tor,

Tor Krill <tor@excito.com> writes:

> Add high speed support to USB code. Extracted from Juniper Networks patch.
>
> I know that the mergewindow is closed but wanted to get feedback on these
> patches if possible.

Thanks again for fixing this up. AFAIK patches look fine, only two
 things:

- please address the issues pointed out by Michael, especially removal
  of the "C" macro.

- Secondly it would be nice if we could have a short README.ehci or
  similar which explains what works and what not, and what needs to be
  done to add further board/HC support.

Thank you in advance.

Best regards

Markus Klotzb?cher

--
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de