From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from wolverine01.qualcomm.com ([199.106.114.254]) by bombadil.infradead.org with esmtps (Exim 4.87 #1 (Red Hat Linux)) id 1clsgW-00012B-B1 for ath10k@lists.infradead.org; Thu, 09 Mar 2017 07:40:29 +0000 From: "Valo, Kalle" Subject: Re: Driver support for QCA6174 chip using SDIO interface Date: Thu, 9 Mar 2017 07:39:58 +0000 Message-ID: <87d1dq6grf.fsf@kamboji.qca.qualcomm.com> References: <8737g45xc7.fsf@kamboji.qca.qualcomm.com> <13839ca7-e43e-8475-04de-8c705c4e3ee2@gmail.com> <3bc420d1-ced9-f0a3-647a-5b81775a543e@gmail.com> In-Reply-To: <3bc420d1-ced9-f0a3-647a-5b81775a543e@gmail.com> (Erik Stromdahl's message of "Wed, 1 Mar 2017 07:25:14 +0100") Content-Language: en-US MIME-Version: 1.0 List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: "ath10k" Errors-To: ath10k-bounces+kvalo=adurom.com@lists.infradead.org To: Erik Stromdahl Cc: Akesh M Chacko , Ann Lo , "ath10k@lists.infradead.org" Hi, sorry for the late reply, I was on vacation and catching up now. Erik Stromdahl writes: > Firmware and board files are normally distributed by the module vendor > (MuRata, Silex, etc.). > > Firmware is depending on chipset, so this is something QCA should be able > to provide. > > Board files are module dependent and contains calibration etc. and should > definitely be obtained from the module vendor. > > If you have a discrete design you would most likely have to create your own > board file (using ART etc.) > > Kalle: > Perhaps you (or someone else at QCA) can initiate the work to make the sdio > firmware publicly available? I'll send a request forward internally, but that might take a while as I'm heavily backlogged at the moment. -- Kalle Valo _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k