Re: [PATCH] Updated 8139too with NAPI

[OGAWA Hirofumi <hirofumi@mail.parknet.co.jp>]

Stephen Hemminger <shemminger@osdl.org> writes:

> @@ -1663,6 +1678,8 @@
>  	/* Disable interrupts by clearing the interrupt mask. */
>  	RTL_W16 (IntrMask, 0x0000);
>  
> +	__netif_poll_disable(dev);

Rx-poll can enable interrupt. However, because it can happen on SMP
only, then reset of chips should be done sooner or later, so I don't
care so much.

> +		/*
> +		 * This order is important
> +		 * (see Documentation/networking/NAPI_HOWTO.txt)
> +		 */
> +		netif_rx_complete(dev);
> +		RTL_W16_F(IntrMask, rtl8139_intr_mask);

    netif_rx_complete(dev);
    -- interrupted --
	in rtl8139_interrupt(),
		if (netif_rx_schedule_prep(dev)) {
			RTL_W16_F (IntrMask, rtl8139_norx_intr_mask);
			__netif_rx_schedule (dev);
		}
    -- resume --
    /* enable interrupt, but rx-poll is already scheduling */
    RTL_W16_F(IntrMask, rtl8139_intr_mask);

So doesn't disable interrupt. Umm... this problem was things that my
patch fixed. Any objections?

		local_irq_disable();
		__netif_rx_complete(dev);
		RTL_W16_F(IntrMask, rtl8139_intr_mask);
		local_irq_enable();
-- 
OGAWA Hirofumi <hirofumi@mail.parknet.co.jp>