Re: [PATCH v5] ALSA: hda/ca0132: Add Sound BlasterX AE-5 external RGB LED strip support

[Takashi Iwai <tiwai@suse.de>]

On Wed, 07 Oct 2026 18:32:14 +0200,
Devin Christensen wrote:
> 
> The Sound BlasterX AE-5 and AE-5 Plus expose a 3-pin 5V addressable RGB
> header driven directly by the CA0113 PCIe-to-HD-Audio bridge. Rather
> than using the CA0132 DSP or MMIO GPIO, the CA0113 contains an
> autonomous HDA link sniffer that snoops a designated HDA DMA playback
> stream, extracts the 24-bit GRB color payload, and serializes it as
> 800 kHz single-wire NRZ pulses to the strip (WS2812B protocol).
> 
> Expose the strip through volatile card control elements:
> 
>   "AE-5 LED Strip"        (RW, BYTES): 300-byte RGB payload representing
>                           up to 100 addressable LEDs (3 bytes per LED).
>   "AE-5 LED Strip Count"  (RW, INTEGER): Active LED count (1..100).
> 
> The controls are marked with IFACE_CARD and SNDRV_CTL_ELEM_ACCESS_VOLATILE
> so changes do not trigger unnecessary audio daemon wakeups or state
> restoration by alsactl.
> 
> Writes allocate an idle HDA playback stream, format a 32 KB DMA buffer
> populated with repeating WS2812 frames (preamble, audio words per LED,
> and reset gap), configure the CA0113 BAR2 serializers and stream-tag
> pin mux, and pulse the stream long enough for the reset latch to fire.
> Access is serialized with a per-spec mutex, and the controls are only
> registered on QUIRK_AE5 devices.
> 
> The strip transport uses snd_hdac_dsp_prepare() / snd_hdac_dsp_cleanup(),
> which require CONFIG_SND_HDA_DSP_LOADER. All strip-related code and struct
> fields are conditionally compiled under
> IS_ENABLED(CONFIG_SND_HDA_DSP_LOADER), with a no-op stub for
> ae5_add_strip_controls() when disabled.
> 
> Signed-off-by: Devin Christensen <dchristensen8@proton.me>

Applied now to for-next branch.  Thanks.


Takashi