Re: [PATCH v4 3/7] platform: cznic: turris-omnia-mcu: Add support for MCU connected GPIOs

[Gregory CLEMENT <gregory.clement@bootlin.com>]

Hello Marek,

> On Thu, 26 Oct 2023 18:17:59 +0200
> Marek Behún <kabel@kernel.org> wrote:
>
>> +	mcu->gc.request = omnia_gpio_request;
>> +	mcu->gc.get_direction = omnia_gpio_get_direction;
>> +	mcu->gc.direction_input = omnia_gpio_direction_input;
>> +	mcu->gc.direction_output = omnia_gpio_direction_output;
>> +	mcu->gc.get = omnia_gpio_get;
>> +	mcu->gc.get_multiple = omnia_gpio_get_multiple;
>> +	mcu->gc.set = omnia_gpio_set;
>> +	mcu->gc.set_multiple = omnia_gpio_set_multiple;
>> +	mcu->gc.init_valid_mask = omnia_gpio_init_valid_mask;
>> +	mcu->gc.can_sleep = true;
>> +	mcu->gc.names = omnia_mcu_gpio_templates;
>> +	mcu->gc.base = -1;
>> +	mcu->gc.ngpio = ARRAY_SIZE(omnia_gpios);
>> +	mcu->gc.label = "Turris Omnia MCU GPIOs";
>> +	mcu->gc.parent = dev;
>> +	mcu->gc.owner = THIS_MODULE;
>
> Sigh. I will need to add a custom of_xlate here that accepts 3 cells
> instead of 2. The reason is that Pali prepared U-Boot code last year to
> patch reset-gpios into pcie nodes if MCU node is present in the
> devicetree, and back then we decided that the binding should be
> 3-celled:
>   reset-gpios = <&mcu BANK GPIO FLAGS>;
>
> So now the pcie controllers do not work because OF cannot give proper
> GPIOs.
>
> I will fix this in v5.

I was reviewing the seris in order to apply it, but I didn't find your
v5 in the mainling list. Did you send it ?

Regards,

Gregory

-- 
Gregory Clement, Bootlin
Embedded Linux and Kernel engineering
http://bootlin.com