From: Jani Nikula <jani.nikula@linux.intel.com>
To: Chris Wilson <chris@chris-wilson.co.uk>, intel-gfx@lists.freedesktop.org
Subject: Re: [PATCH 2/4] drm/i915/dvo: Remove incorrect kerneldoc markups
Date: Wed, 14 Feb 2018 12:25:06 +0200 [thread overview]
Message-ID: <87po576f7h.fsf@intel.com> (raw)
In-Reply-To: <20180214092909.27040-2-chris@chris-wilson.co.uk>
On Wed, 14 Feb 2018, Chris Wilson <chris@chris-wilson.co.uk> wrote:
> Regular comments where being marked up for kerneldoc, but were not
> formatted properly. Remove the markup to remove the warnings.
>
> drivers/gpu/drm/i915/dvo_ivch.c:192: warning: Function parameter or member 'dvo' not described in 'ivch_read'
> drivers/gpu/drm/i915/dvo_ivch.c:192: warning: Function parameter or member 'addr' not described in 'ivch_read'
> drivers/gpu/drm/i915/dvo_ivch.c:192: warning: Function parameter or member 'data' not described in 'ivch_read'
>
> Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Could switch the comments to imperative while at it, but *shrug*.
Reviewed-by: Jani Nikula <jani.nikula@intel.com>
> ---
> drivers/gpu/drm/i915/dvo_ivch.c | 28 ++++++++++++++--------------
> 1 file changed, 14 insertions(+), 14 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/dvo_ivch.c b/drivers/gpu/drm/i915/dvo_ivch.c
> index 4950b82f5b49..c73aff163908 100644
> --- a/drivers/gpu/drm/i915/dvo_ivch.c
> +++ b/drivers/gpu/drm/i915/dvo_ivch.c
> @@ -59,28 +59,28 @@
> * This must not be set while VR01_DVO_BYPASS_ENABLE is set.
> */
> # define VR01_LCD_ENABLE (1 << 2)
> -/** Enables the DVO repeater. */
> +/* Enables the DVO repeater. */
> # define VR01_DVO_BYPASS_ENABLE (1 << 1)
> -/** Enables the DVO clock */
> +/* Enables the DVO clock */
> # define VR01_DVO_ENABLE (1 << 0)
> -/** Enable dithering for 18bpp panels. Not documented. */
> +/* Enable dithering for 18bpp panels. Not documented. */
> # define VR01_DITHER_ENABLE (1 << 4)
>
> /*
> * LCD Interface Format
> */
> #define VR10 0x10
> -/** Enables LVDS output instead of CMOS */
> +/* Enables LVDS output instead of CMOS */
> # define VR10_LVDS_ENABLE (1 << 4)
> -/** Enables 18-bit LVDS output. */
> +/* Enables 18-bit LVDS output. */
> # define VR10_INTERFACE_1X18 (0 << 2)
> -/** Enables 24-bit LVDS or CMOS output */
> +/* Enables 24-bit LVDS or CMOS output */
> # define VR10_INTERFACE_1X24 (1 << 2)
> -/** Enables 2x18-bit LVDS or CMOS output. */
> +/* Enables 2x18-bit LVDS or CMOS output. */
> # define VR10_INTERFACE_2X18 (2 << 2)
> -/** Enables 2x24-bit LVDS output */
> +/* Enables 2x24-bit LVDS output */
> # define VR10_INTERFACE_2X24 (3 << 2)
> -/** Mask that defines the depth of the pipeline */
> +/* Mask that defines the depth of the pipeline */
> # define VR10_INTERFACE_DEPTH_MASK (3 << 2)
>
> /*
> @@ -97,7 +97,7 @@
> * Panel power down status
> */
> #define VR30 0x30
> -/** Read only bit indicating that the panel is not in a safe poweroff state. */
> +/* Read only bit indicating that the panel is not in a safe poweroff state. */
> # define VR30_PANEL_ON (1 << 15)
>
> #define VR40 0x40
> @@ -183,7 +183,7 @@ struct ivch_priv {
>
>
> static void ivch_dump_regs(struct intel_dvo_device *dvo);
> -/**
> +/*
> * Reads a register on the ivch.
> *
> * Each of the 256 registers are 16 bits long.
> @@ -230,7 +230,7 @@ static bool ivch_read(struct intel_dvo_device *dvo, int addr, uint16_t *data)
> return false;
> }
>
> -/** Writes a 16-bit register on the ivch */
> +/* Writes a 16-bit register on the ivch */
> static bool ivch_write(struct intel_dvo_device *dvo, int addr, uint16_t data)
> {
> struct ivch_priv *priv = dvo->dev_priv;
> @@ -258,7 +258,7 @@ static bool ivch_write(struct intel_dvo_device *dvo, int addr, uint16_t data)
> return false;
> }
>
> -/** Probes the given bus and slave address for an ivch */
> +/* Probes the given bus and slave address for an ivch */
> static bool ivch_init(struct intel_dvo_device *dvo,
> struct i2c_adapter *adapter)
> {
> @@ -338,7 +338,7 @@ static void ivch_reset(struct intel_dvo_device *dvo)
> ivch_write(dvo, backup_addresses[i], priv->reg_backup[i]);
> }
>
> -/** Sets the power state of the panel connected to the ivch */
> +/* Sets the power state of the panel connected to the ivch */
> static void ivch_dpms(struct intel_dvo_device *dvo, bool enable)
> {
> int i;
--
Jani Nikula, Intel Open Source Technology Center
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2018-02-14 10:25 UTC|newest]
Thread overview: 10+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-02-14 9:29 [PATCH 1/4] drm/i915/crt: Remove obsolete kerneldoc-esque comment Chris Wilson
2018-02-14 9:29 ` [PATCH 2/4] drm/i915/dvo: Remove incorrect kerneldoc markups Chris Wilson
2018-02-14 10:25 ` Jani Nikula [this message]
2018-02-14 10:32 ` Chris Wilson
2018-02-14 9:29 ` [PATCH 3/4] drm/i915/dvo: Fixup commentary Chris Wilson
2018-02-14 10:25 ` Jani Nikula
2018-02-14 9:29 ` [PATCH 4/4] drm/i915/lvds: " Chris Wilson
2018-02-14 10:25 ` Jani Nikula
2018-02-14 10:24 ` [PATCH 1/4] drm/i915/crt: Remove obsolete kerneldoc-esque comment Jani Nikula
2018-02-14 11:42 ` ✗ Fi.CI.BAT: failure for series starting with [1/4] " Patchwork
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87po576f7h.fsf@intel.com \
--to=jani.nikula@linux.intel.com \
--cc=chris@chris-wilson.co.uk \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.