From: Miquel Raynal <miquel.raynal@bootlin.com>
To: Richard Weinberger <richard@nod.at>,
Miquel Raynal <miquel.raynal@bootlin.com>
Cc: Tudor Ambarus <Tudor.Ambarus@linaro.org>,
Vignesh Raghavendra <vigneshr@ti.com>,
Frieder Schrempf <frieder.schrempf@kontron.de>,
Michael Walle <michael@walle.cc>,
Pratyush Yadav <pratyush@kernel.org>,
linux-mtd@lists.infradead.org
Subject: [GIT PULL] mtd: nand: Changes for 6.16
Date: Mon, 02 Jun 2025 18:38:47 +0200 [thread overview]
Message-ID: <87tt4yksiw.fsf@bootlin.com> (raw)
Hello,
This is the NAND PR for 6.16.
Thanks,
Miquèl
The following changes since commit 8ffd015db85fea3e15a77027fda6c02ced4d2444:
Linux 6.15-rc2 (2025-04-13 11:54:49 -0700)
are available in the Git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux.git tags/nand/for-6.16
for you to fetch changes up to 3bfb22cecfe6b6f0d8ee56ef4b533cf68599c5d9:
mtd: rawnand: brcmnand: legacy exec_op implementation (2025-05-26 11:32:33 +0200)
----------------------------------------------------------------
The SPI NAND subsystem has seen the introduction of DTR operations (the
equivalent of DDR transfers), which involved quite a few preparation
patches for clarifying macro names.
In the raw NAND subsystem, the brcmnand driver has been "fixed" for old
legacy SoCs with an update of the ->exec_op() hook, there has been the
introduction of a new controller driver named Loongson-1, and the
Qualcomm driver has received quite a few misc fixes as well as a new
compatible.
Aside from this, there is the usual load of misc improvement and fixes.
----------------------------------------------------------------
Dan Carpenter (1):
mtd: rawnand: loongson1: Fix error code in ls1x_nand_dma_transfer()
David Regan (1):
mtd: nand: brcmnand: fix NAND timeout when accessing eMMC
George Moussalem (1):
mtd: spinand: esmt: fix id code for F50D1G41LB
Kaushal Kumar (1):
dt-bindings: mtd: qcom,nandc: Document the SDX75 NAND controller
Keguang Zhang (3):
dt-bindings: mtd: Add Loongson-1 NAND Controller
mtd: rawnand: Add Loongson-1 NAND Controller Driver
mtd: rawnand: loongson1: Fix inconsistent refcounting in ls1x_nand_chip_init()
Md Sadre Alam (3):
mtd: rawnand: qcom: Pass 18 bit offset from NANDc base to BAM base
mtd: rawnand: qcom: Fix last codeword read in qcom_param_page_type_exec()
mtd: rawnand: qcom: Fix read len for onfi param page
Mikhail Arkhipov (1):
mtd: nand: ecc-mxic: Fix use of uninitialized variable ret
Miquel Raynal (19):
mtd: spinand: Use more specific naming for the reset op
mtd: spinand: Use more specific naming for the write enable/disable op
mtd: spinand: Use more specific naming for the read ID op
mtd: spinand: Use more specific naming for the get/set feature ops
mtd: spinand: Use more specific naming for the erase op
mtd: spinand: Use more specific naming for the page read op
mtd: spinand: Use more specific naming for the (single) read from cache ops
mtd: spinand: Use more specific naming for the (dual output) read from cache ops
mtd: spinand: Use more specific naming for the (dual IO) read from cache ops
mtd: spinand: Use more specific naming for the (quad output) read from cache ops
mtd: spinand: Use more specific naming for the (quad IO) read from cache ops
mtd: spinand: Use more specific naming for the program execution op
mtd: spinand: Use more specific naming for the (single) program load op
mtd: spinand: Use more specific naming for the (quad) program load op
mtd: spinand: Define octal operations
mtd: spinand: winbond: Rename DTR variants
mtd: spinand: winbond: Add support for W35N01JW in single mode
mtd: spinand: winbond: Add octal support
mtd: spinand: winbond: Add support for W35N02JW and W35N04JW chips
Philipp Stanner (1):
mtd: rawnand: Use non-hybrid PCI devres API
Wentao Liang (3):
mtd: bcm47xxnflash: Add error handling for bcm47xxnflash_ops_bcm4706_ctl_cmd()
mtd: nand: sunxi: Add randomizer configuration before randomizer enable
mtd: rawnand: sunxi: Add randomizer configuration in sunxi_nfc_hw_ecc_write_chunk
Álvaro Fernández Rojas (2):
mtd: rawnand: brcmnand: remove unused parameters
mtd: rawnand: brcmnand: legacy exec_op implementation
.../mtd/loongson,ls1b-nand-controller.yaml | 72 ++
.../devicetree/bindings/mtd/qcom,nandc.yaml | 30 +-
MAINTAINERS | 1 +
drivers/mtd/nand/ecc-mxic.c | 2 +-
drivers/mtd/nand/qpic_common.c | 8 +-
drivers/mtd/nand/raw/Kconfig | 7 +
drivers/mtd/nand/raw/Makefile | 1 +
drivers/mtd/nand/raw/bcm47xxnflash/ops_bcm4706.c | 5 +-
drivers/mtd/nand/raw/brcmnand/brcmnand.c | 248 +++++-
drivers/mtd/nand/raw/denali_pci.c | 13 +-
drivers/mtd/nand/raw/loongson1-nand-controller.c | 836 +++++++++++++++++++++
drivers/mtd/nand/raw/qcom_nandc.c | 18 +-
drivers/mtd/nand/raw/sunxi_nand.c | 2 +
drivers/mtd/nand/spi/alliancememory.c | 20 +-
drivers/mtd/nand/spi/ato.c | 14 +-
drivers/mtd/nand/spi/core.c | 20 +-
drivers/mtd/nand/spi/esmt.c | 22 +-
drivers/mtd/nand/spi/foresee.c | 16 +-
drivers/mtd/nand/spi/gigadevice.c | 60 +-
drivers/mtd/nand/spi/macronix.c | 20 +-
drivers/mtd/nand/spi/micron.c | 38 +-
drivers/mtd/nand/spi/paragon.c | 20 +-
drivers/mtd/nand/spi/skyhigh.c | 20 +-
drivers/mtd/nand/spi/toshiba.c | 22 +-
drivers/mtd/nand/spi/winbond.c | 128 +++-
drivers/mtd/nand/spi/xtx.c | 20 +-
drivers/spi/spi-qpic-snand.c | 1 +
include/linux/mtd/nand-qpic-common.h | 4 +-
include/linux/mtd/spinand.h | 121 +--
29 files changed, 1521 insertions(+), 268 deletions(-)
create mode 100644 Documentation/devicetree/bindings/mtd/loongson,ls1b-nand-controller.yaml
create mode 100644 drivers/mtd/nand/raw/loongson1-nand-controller.c
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next reply other threads:[~2025-06-02 16:38 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-06-02 16:38 Miquel Raynal [this message]
2025-06-02 16:48 ` [GIT PULL] mtd: nand: Changes for 6.16 Miquel Raynal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87tt4yksiw.fsf@bootlin.com \
--to=miquel.raynal@bootlin.com \
--cc=Tudor.Ambarus@linaro.org \
--cc=frieder.schrempf@kontron.de \
--cc=linux-mtd@lists.infradead.org \
--cc=michael@walle.cc \
--cc=pratyush@kernel.org \
--cc=richard@nod.at \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.