From mboxrd@z Thu Jan 1 00:00:00 1970 From: gregory.clement@free-electrons.com (Gregory CLEMENT) Date: Thu, 07 Apr 2016 15:09:06 -0700 Subject: [PATCH v2] ARM: dts: orion5x: add device tree for kurobox-pro In-Reply-To: <20160404123508.GF21828@lunn.ch> (Andrew Lunn's message of "Mon, 4 Apr 2016 14:35:08 +0200") References: <1458656898-16183-1-git-send-email-rogershimizu@gmail.com> <1459267905-15403-1-git-send-email-rogershimizu@gmail.com> <20160404123508.GF21828@lunn.ch> Message-ID: <87twjdhy0t.fsf@free-electrons.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Roger, On lun., avril 04 2016, Andrew Lunn wrote: > On Wed, Mar 30, 2016 at 01:11:45AM +0900, Roger Shimizu wrote: >> Add dts file to support Buffalo/Revogear Kurobox-Pro, which is marvell >> orion5x based 3.5" HDD NAS. >> >> It's a quite old product and already discontinued. So there's no >> official website for it. But it was an early product which used marvell >> orion5x 88F5182 chipset, it's popular in the community. >> Some unofficial site: >> - http://buffalo.nas-central.org/wiki/Category:KuroboxPro >> - http://nice.kaze.com/KUROPRO_ProductSpecifications.pdf >> >> This device tree is based on the board file: >> arch/arm/mach-orion5x/kurobox_pro-setup.c >> However, the probing order of NAND and JEDEC-Flash are different from >> the original board file, this results in incompatible minor number >> for a few /dev/mtdX and /dev/mtdblockX devices. >> So I still want to keep the board file for the time being. >> >> Signed-off-by: Roger Shimizu > > Hi Roger > > Looks good: > > Reviewed-by: Andrew Lunn Applied on mvebu/dt Thanks, Gregory > > Andrew -- Gregory Clement, Free Electrons Kernel, drivers, real-time and embedded Linux development, consulting, training and support. http://free-electrons.com